Owner's Manual

5. Screw in the leveling legs (P6).The leveling legs (P6) have a flat

side designed for use with an adjustable wrench, if needed.

IMPORTANT: To install the leveling legs (P6), turn clockwise a

minimum of 1¹⁄₂" (3.8 cm) (12 full turns). Further adjustment can

be made ³⁄₄" (1.9 cm) up or down from this position or until the

leveling leg cannot be turned any further against the bottom of

the inner leg (P2).

NOTE: Before setting workbench upright, verify that the same

number of adjustment holes are visible on each leg to ensure that the

workbench will be level.

Complete the Assembly

1. Using two or more people, stand the workbench upright and

place it in its final location.

2. Adjust the leveling legs as needed.

Workbench Care

1. Wash the workbench with a mild detergent and warm water. Do

not allow water to remain on the workbench for any length of

time.

2. Rinse completely and dry thoroughly.

WARNING

Excessive Weight Hazard

Use two or more people to move and assemble

workbench.

Failure to do so can result in back or other injury.