Manual

2
CABINET/LOCKER SAFETY
INSTALLATION INSTRUCTIONS
Tools and Parts
Gather the required tools and parts before starting installation.
Tools Needed:
Parts Needed for Standard Mount:
Parts Supplied for 24" (60.96 cm) Cabinet:
Parts Supplied for 30" (76 cm) Cabinet:
Cabinet Use Requirements
■ Intended for use in a garage.
■ Maximum weight limit is 50 lbs (22 kg) for each shelf.
■ Maximum weight limit is 150 lbs (68 kg) for the 24" (60.96 cm)
cabinet.
■ Maximum weight limit is 200 lbs (91 kg) for the 30" (76 cm)
cabinet.
Unpack the Cabinet
1. Open the cabinet door.
NOTE: On the 30" (76 cm) cabinet you must first remove the key,
located in the handle, and unlock the door.
2. Remove and verify the contents. See “Parts Supplied” in “Tools
and Parts.”
3. Dispose of/recycle all packaging materials.
Install the Cabinet to the Wall
IMPORTANT: Decide if you are going to mount the cabinet on
Gladiator
®
GearWall
®
panels or GearTrack™ channels, or on a
standard wall. Follow the instructions that apply to your installation.
Install Cabinet to GearWall
®
Panels or
GearTrack™ Channels
IMPORTANT:
■ Be sure the Gladiator
®
GearWall
®
panels or GearTrack™ channels
are installed with mounting screws in every slot and at every stud
location with a maximum of 24" (60.96 cm) horizontally between
screws.
■ If Gladiator
®
GearTrack™ channels will be used to mount the
Welded-Steel Wall GearBox cabinet, they must be installed 18"
(45.72 cm) apart.
You can be killed or seriously injured if you don't immediately
You
can be killed or seriously injured if you don't
follow
All safety messages will tell you what the potential hazard is, tell you how to reduce the chance of injury, and tell you what can
happen if the instructions are not followed.
Your safety and the safety of others are very important.
We have provided many important safety messages in this manual and on your appliance. Always read and obey all safety
messages.
This is the safety alert symbol.
This symbol alerts you to potential hazards that can kill or hurt you and others.
All safety messages will follow the safety alert symbol and either the word “DANGER” or “WARNING.”
These words mean:
follow instructions.
instructions.
DANGER
WARNING
■ ¹⁄₂" Wrench (GearWall
®
panel
or GearTrack™ channel mount)
■ Phillips screwdriver
■ ⁷⁄₁₆" Wrench (Standard
mount)
■ ¹⁄₄" – 20 x 1¹⁄₂" Lag screws (4) ■ ¹⁄₄" Flat washers (4)
■ Full-width shelf (1)
■ Mounting bracket (1)
■ ¹⁄₄" x ¹⁄₂" Carriage bolts (2)
■ Hex nuts (2)
■ Washers (2)
■ Full-width shelves (2)
■ Mounting brackets (2)
■ ¹⁄₄" x ¹⁄₂" Carriage bolts (4)
■ Hex nuts (4)
■ Washers (4)
■ Key (1)
WARNING
Excessive Weight Hazard
Use two or more people to move, assemble or install
cabinet or locker.
Failure to do so can result in back or other injury.
18" (46 cm)