Installation Instructions

Remote Instructions
Here are the commands that can be used with the flex light remote:
1 YEAR LIMITED WARRANTY: LEDVANCE warrants the Product to be free from defects in materials and workmanship from
date of purchase for the specified warranty period when used as directed. Failure to comply with Product warnings and
instructions shall void the warranty. This warranty does not cover Product subject to accident, neglect, abuse, misuse,or acts
of God. If Product fails to operate according to the warranty, return Product to place of purchase with proof of purchase date
and LEDVANCE will replace with the same or similar Product free. For additional information, contact 1-800 LIGHTBULB
(1-800-544-4828); Email: [e-mail]. THIS IS THE EXCLUSIVE REMEDY AVAILABLE. LIABILITY FOR
INCIDENTAL OR CONSEQUENTIAL DAMAGES IS EXPRESSLY EXCLUDED. SOME STATES AND JURISDICTIONS DO NOT
ALLOW THE EXCLUSION OR LIMITATION OF INCIDENTAL OR CONSEQUENTIAL DAMAGES, SO THE ABOVE LIMITATION
OR EXCLUSION MAY NOT APPLY TO YOU. THIS WARRANTY GIVES YOU SPECIFIC LEGAL RIGHTS, AND YOU MAY ALSO
HAVE OTHER RIGHTS WHICH VARY FROM STATE TO STATE OR PROVINCE.
FCC Statement:
This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to part 15 of the
FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation.
This equipment generates, uses and can radiate radio frequency energy and, if not installed and used in accordance with the
instructions, may cause harmful interference to radio communications. However,there is no guarantee that interference will
not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which
can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or
more of the following measures:
1) Reorient or relocate the receiving antenna.
2) Increase the separation between the equipment and receiver.
3) Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
4) Consult the dealer or an experienced radio/TV technician for help.
This device complies with part 15 of the FCC Rules. Operation is subject to the following two conditions:
(1) This device may not cause harmful interference, and (2) this device must accept any interference received, including interference
that may cause undesired operation.
Any changes or modifications to this device not explicitly approved by manufacturer could void your authority to operate this
equipment.
Imported by: LEDVANCE LLC
1100 Tyrone Pike Versailles,KY 40383
Made in China
Troubleshooting remote connection
Warranty
If for some reason the remote does not connect to the strip’s controller, please re-pair it following these steps:
1. Turn off the power for about 5 seconds by switching to “OFF” on the battery box.
2. Check the remote battery if it is installed properly.
3. Check the battery box batteries if they are installed properly.
4. Switch the battery box toggle to “ON” and check to see if it is working.
Brightness / frequency down
Brightness / frequency up
Red / Green / Blue
Other colors
On
White
Flash
Strobe
Fade
Smooth
Off
CAUTION: