Installation Guide

EnduroShield makes cleaning easier and less frequent; however it
is recommended that you continue to clean the surfaces regularly.
Care & Maintenance
Maintaining the Treated Surface
For best results simply drying the glass with a squeegee
or towel aer each use will help keep the glass clean
and reduce mineral spots forming. The glass needs to
be cleaned every few weeks using a damp microfiber
cloth and a mild detergent to break down soaps, oils,
and conditioners on the glass. General glass cleaners
are also suitable, however most of these are finishing
agents rather than cleaners, and are an added expense
that is not required.
Hard Water Maintenance
In hard water areas, or areas where water drops dry and
leave a noticeable dust mark, a build of minerals may
occur on the protective treatment. While these may
not be removed as easily with the mild detergent, mild
acids will oen remove the marks quickly. As needed
white vinegar should be used to wipe down the glass.
Keep in mind the vinegar may be diluted with water,
however dilution reduces the eectiveness.
Spray vinegar onto the glass and allow to soak for several
minutes. This should dissolve any mineral deposits that
have built up on the glass surface. A damp microfiber
cloth should then be used to wipe over the surface.
For extreme hard water areas we recommended using
undiluted vinegar every week or so as a cleaning option
to reduce this build up on the surface, rather than
allowing the build up to continue over a long period of
time.
Caution: Prohibited Products *Note these may damage
the treatment and void any warranty
• Avoid the use of any abrasives or polishes including
water spot removers, toothpaste, polishes, rough, or
griy substances
• Avoid the use of acids or alkalis that you would
not want in contact with your skin for an extended
period of time
• Avoid products such as Comet, Ajax, Ji or Cerium
Oxide which polish back the actual substrate
• Avoid the use of any harsh or chemical cleaners,
with correct maintenance these are never required
Approved Cleaning Products
The below products have been tested for compatibility
with EnduroShield, however there are no specific
products that must be used. We feel you should not be
required to purchase extra products in order to keep
your glass clean. With correct maintenance, all you
need for clean glass beyond 10 years is a squeegee, a
mild liquid dish soap, and white vinegar.
Any product that does not fall into the prohibited
categories listed above will be fine, and below is a short
list of acceptable products:
• Windex
• SprayWay (or other alcohol based foaming cleaners)
• Scrubbing Bubbles (or other automatic leave-to-dry
daily shower cleaners)
• 7th Generation, Dawn (or other mild eco
friendly cleaners)
• CLR (Calcium Lime Rust)
• Mr. Clean Magic Eraser (when damp)
It should be noted that with any cleaner used on the
EnduroShield surface a thorough rinse with clean water
should follow immediately. Although these cleaners can
be used, EnduroShield is designed to be an ‘easy clean
coating’ that does not require harsh or toxic cleaning
chemicals to maintain the surface eectively.
If for any reason the recommended maintenance has
not been followed for some time, just as it took time
for the build up to occur, it will take time to remove the
debris from the protected glass surface. This can most
commonly be achieved using undiluted white vinegar
dampened on a Magic Eraser, or CLR on a Magic Eraser.
Depending on the severity of the build up this may take
multiple aempts, but once the glass is clean again
it will perform like new. Should you have any queries
regarding the cleaning of your treated surfaces please
contact EnduroShield.
tel: [phone]
email: [e-mail]
www.enduroshield.com