Installation Guide

Important: This panel is fully reversible
and can be installed on right or le
hand wall as needed.
If installing an enclosure with fiberglass
walls, a stud must be directly behind
where the panel will be installed.
Tip: We recommend marking with
a pencil for easy removal.
Measure and mark the Fixed Panel location.
Use a level and mark a line up the wall on the side
you wish to place the Fixed Panel. Along the shower
base threshold, draw a line equal measure in from the
front edge of the threshold. This is your center line for
the Clips.
01 02
Mark locations for Clips.
A 70" from the shower base threshold, up the vertical
line for the first Wall Clip.
B 8" from the shower base threshold, up the vertical
line for the second Wall Clip.
C Measure the width of Fixed Panel and subtract
3 ½". Measure this distance out from wall and mark
on shower base threshold. This is for the Boom
Clip or the Rubber Block option.
Subtract 31⁄2" from
Fixed Panel width.
8"
70"
Important: The third Clip for the boom
of the Panel is optional. If you prefer not
to drill into your fiberglass shower base,
see step 8.