Installation Guide

Important: If installing an enclosure with
fiberglass walls, a stud must be directly
behind where the panel will be installed.
A ⁄" tile drill bit can be used to create
pilot holes for a tiled enclosure,
but this is optional.
04
Fix Wall Clips for Fixed Panel.
Place Wall Clips over holes and drill in screws to secure
the Clips. Be sure grub screws on Clips are facing
the shower interior. Make sure the clips are securely
tightened to the wall.
Position
grub screw
to inside
of shower
03
Drill holes for Wall Clips.
Using a ⁄" drill bit, drill holes and install the wall anchors.
Trim excess from the wall anchors hanging out of hole
with utility knife so clips sit flush to wall.
If the shower wall is fiberglass, use a ⅛" drill bit for
the wall holes. You will not use the green Anchor but
rather screw the Wall Clips directly into the fiberglass
shower wall.
Important: Grub screw in Clip must have
rubber tip so it can contact glass panel
without damage. Please contact us if
grub screw is missing rubber tip.