Installation Guide

09
Install and level Fixed Panel into Wall Clips and onto
Rubber Blocks.
Carefully place Fixed Panel into Wall Clips and on to
Rubber Blocks. Make sure the Fixed Panel is set all the
way into the Wall Clips. Use a level to make sure the
Fixed Panel is level. Tighten Clip screws.
10
Trim Rubber Blocks.
Trim the Rubber Block with a utility knife so that
it is flush with the Glass Panel resting on top. The
Rubber Blocks remain under the Glass Panel. Do not
remove them.
If you used 2 Rubber Blocks on your fiberglass shower
base instead of the Boom Clip, trim excess o of both
blocks on both sides of glass panel.
Tip: Use additional rubber blocks on
either existing blocks to raise/drop
the fixed panel if required.