Installation Guide
05
Drill hole for Boom Clip option.
If you are not drilling into your shower base and prefer
the Rubber Blocks option instead of using the Boom
Clip, please go to step 8.
If the shower base is fiberglass, use a ⅛" drill bit for the
third hole. You will not use the Wall Anchor but rather
screw the Boom Clip directly into the fiberglass base.
If the threshold is tiled, use the same ¼" tile drill bit to
drill the third hole on the threshold. Insert Anchor.
Be sure to put a dob of silicone inside hole drilled for the
Boom Clip.
Do not drill if using optional
⁄" Rubber Blocks instead
of Bottom Clip. Please see
step 8 for more info.
06
3 1⁄2"
Position
grub screw
to inside
of shower
Install Fixed Panel Boom Clip and Rubber Block.
Install Fixed Panel Boom Clip and place a ⁄" rubber
block inside the Boom Clip to protect Fixed Panel
during installation. Place ⁄" thick Rubber Block provided
3 ½" in from where the Fixed Panel and wall meet where
the glass panel will sit on the tile or threshold.
Tip: Use additional rubber blocks on
either existing blocks to raise/drop
the fixed panel if required.