Owner Manual

ManualsBrandsGlass Warehouse ManualsAlcove Shower Doors57.5 in. x 78 in. Frameless Wall Hinged Shower Door in Brushed Nickel

INSTALLATION VIDEO

VIMEO LINK

https://vimeo.com/352533332

Follow the link above to view installation animation video to assist

in installing your brand new

Glass Warehouse Wall Hinge Shower Enclosure

For further assistance, contact GW at: inquiries@glasswarehouse.us

Summary of content (8 pages)

PAGE 1
INSTALLATION VIDEO VIMEO LINK https://vimeo.com/352533332 Follow the link above to view installation animation video to assist in installing your brand new Glass Warehouse Wall Hinge Shower Enclosure For further assistance, contact GW at: inquiries@glasswarehouse.
PAGE 2
WH Shower Enclosure Installation Guide (Wall Hinge Model) GAP RANGE WALL - DOOR = 3/16” to 5/16” DOOR - FIXED PANEL = 1/8” to 1/4” DOOR PANEL 1/4” FIXED PANEL - WALL = 1/8” to 3/8” FIXED PANEL 1/8” 1/8”
PAGE 3
BEFORE YOU START The most fragile parts of tempered glass panels are the corners. Therefore, it is critical you have the rubber blocks in place so the glass never touches the tile surface you are installing onto. Please make sure the glass is always on blocks while out of the packaging prior/during install. Rubber block is provided in your hardware pack however you can use wood, cardboard or other rubber products to protect against breakage. Silicon is not provided this will need to be purchased separately.
PAGE 4
b. 4. 5. 6. 7. 8. 9. Lightly tighten each screw with the allen key provided so the hinges are lightly secure only. They are going to be removed again. i. TIP: Center each hinge to the glass cutout allowing some space to adjust the height of the door panel once installed. Attach the door handle to the door panel. i. IMPORTANT: Ensure the handle is firmly attached. ii.
PAGE 5
PART THREE – Silicone Fixed Panel IMPORTANT: Siliconing your panel is essential as not only does this prevent your panel from leaking water it is also imperative to the integrity and strength of the shower enclosure. 1. 2. Silicone both the inside and outside of the wall and floor surface of the fixed panel. i. TIP: Spraying the silicone with water after applying the silicone and using a spatula of some kind to remove the silicone residue will give you a nice clean and professional finish.
PAGE 6
Care & Maintenance EnduroShield makes your cleaning easier and less frequent; however it is recommended that you continue to clean the surfaces regularly. Maintaining the Treated Surface For best results simply drying the glass with a squeegee or towel after each use will help keep the glass clean and reduce mineral spots forming. The glass needs to be cleaned every few weeks using a damp microfiber cloth and a mild detergent to break down soaps, oils, and conditioners on the glass.
PAGE 7
PAGE 8
• • • • •