Installation

Decorative Wall Mirror
Installation Instructions
Congratulations on your purchase of Americas nest Mirrored Cabinet Accessories by GlassCrafters, Inc.
World class engineering and state of the art design will enable you to enjoy your wall mirror & cabinet for many years to
come. We realize that the marketplace offers many choices and we thank you for selecting
GlassCrafters for your bath mirror and cabinet needs.
The following instruction sheet must be used with the Mirrored Cabinet installation instructions
and the Center Shelf installation sheet.
Please use extreme care while unpacking and handling your GlassCrafters’ Decorative Wall Mirror & Accessories.
Report any damage immediately to our GlassCrafters customer service team at 800-233-7362,
Monday thru Friday from 8:00 am to 5:00 pm (EST)
To properly install your GlassCrafter Decorative Wall Mirror you
must determine the height and width of the mirror. The following in-
stallation guide will walk you through the installation of a C-FM-
3030 mirror.
Determine the height above the nished oor or sink cabi-
net. ( Note: when installing with Mirrored cabinets the cabinets re-
quire a minimum of 1” above any faucet height or other obstruction
for the door swing). Scribe a level horizontal line for the base of the
mirror.
Determine the width of the entire unit you are installing.
Scribe a plumb center line for the position of this unit. The sample
mirror is 30” wide so you would mark the left and right edge of the
mirror 15” on either side of the centerline.
Measure up 24” from the horizontal base line and make a
level horizontal line for the location of the bottom Wall Mount Mirror
Bracket (466-00).
Measure in from the marks for the left and right edge of the
mirror and mark this position. Hold the Wall Mount Bracket on the
inside of each mark and scribe the hole position for each bracket.
Drill the holes using a 3/16” masonry bit. Insert one plastic wall an-
chor (#10PWA) in each hole. Using the wall anchor screws (#10x1
1/2”) Phillips Screws) fasten each bracket to the wall. Test the t of
the mirror.
Your GlassCrafters Wall Mirror has the Single Mirror
Bracket (#465-00) pre-installed to the backside of the mirror along
with the three foam pads.
If this Wall Mirror is being installed with Mirrored Cabinets
follow the cabinet instructions for the order of installation.
When you are ready to install the Wall Mirror remove the
tape from the foam pads and carefully lower the mirror onto the wall
bracket to a level position. Do not let the foam pads adhere to the
wall prior to the nal position of the mirror. Check to make sure that
both brackets are properly engaged before releasing the mirror.
Apply slight pressure to engage the foam pads
NOTE ON CLEANING: If the mirror requires cleaning use a house-
hold liquid glass cleaner. Do not spray cleaner directly on the mirror,
spray cleaner on a soft cloth or paper towel. Never use abrasive
cleaner or cleanser containing ammonia. This may cause chemical
damage to the mirror and void the warranty.
24”
Horizontal position of
Wall Brackets --
Mirror width less 5”
equally spaced on centerline
Front
Back
Revised 05/2016
GLASSCRAFTERS, INC
193 Veterans Blvd., Carlstadt, NJ 07072
1+[phone] (F) 1+[phone]
[e-mail]