Installation

13
INSTALL THE OUTER DOOR:
(Note: the Outer Glass Door has an identifying label.)
STEP 15. Install the Outer Roller assemblies in the
predrilled holes in the outer glass door.
• The Roller assemblies go on the inside of the door.
• Be sure to use the plastic washers fittings as supplied in
the assembled Rollers to protect the glass from metal
elements.
•Tighten the Roller into position from the outside of the
door. Do not overtighten as the final adjustment of the
door operation may be required.
• BE SURE THAT THE “ANTI-LIFT” SCREW GROOVES IN THE
CENTER OF THE ROLLER -- AS VIEWED FROM THE INSIDE--
ARE PERPENDICULAR TO THE EDGE OF THE GLASS.
(See Detail 15C)
• Do not install the Outer Roller Cap or the Outer
Roller Back Plate and screw until after the doors are
finally adjusted.
90.00°
Detail 15B
Detail 15C As viewed from the
inside of the door
BE SURE THAT THE “ANTI-LIFT” SCREW GROOVES IN THE
CENTER OF THE ROLLER -- AS VIEWED FROM THE INSIDE--
ARE PERPENDICULAR TO THE EDGE OF THE GLASS.
Do not install the Outer Roller Cap or the Outer Roller
Back Plate and screw until after the doors are finally
adjusted.
Outer Roller Cap
Outer Roller Back Plate
Anti-Lift Screw Grooves
Anti-Lift Screw Grooves
Plastic Washers
and Fittings
Detail 15A - Exploded View of
the Outer Roller Assembly