Installation

9
Hinge Cover Name Plate
#1 Screw -
Adjust Left to Right
#3 Screw -
Adjust
Front to Back
#2 Screw -
Adjust
Top to Bottom
1) Insert into
H
inge Toe
first
Hinge Plate
2) Lift and snap
into place
Door with Hinge
After door adjustments are completed place cover caps on hinges.
Blum Hinge Adjustment
#3
Screws adjust
for Flush Fit
to cabinet face
#2
Screws adjust
for Fit to
Top and Bottom
to cabinet face
#1
Screws adjust
for Fit alignmen
left and right
to cabinet face
Hinge Plate*
Factory Installed.
*If the door binds and does
not fully close, adjust the
Hinge Plate on the cabinet up
and down, to relieve the ten-
sion
Door Installation
The doors are packed individually for protection of the
mirror surfaces. Carefully remove the door from the
carton.* Hold the door in the upright position snap
open the factory installed hinges. Place the hinge onto
the factory-installed mounting plate in the cabinet --
Toe rst -- and snap into position. Be careful not to
chip the door mirror.
Cabinets are supplied with left or right hinges. Be sure to install
with the correct hinged side as per the room plans.
*Do not remove corner protectors until the door is
installed. Removing the Door Protectors prior to
installation will damage the mirror.
Hinge Toe Plate
Corner Protectors
To view a video showing helpful tips on how to adjust our cabinet
hinges, please go to GlassCraftersMirroredCabinets.com and
navigate to the cabinet product that you are installing.
Simply click on the installation tab (located below the
product images) to view our installation videos.