Installation

13
#3
Screws adjust
for Flush Fit
to cabinet face
#2
Screws adjust
for Fit to
Top and Bottom
to cabinet face
#1
Screws adjust
for Fit alignment
left and right
to cabinet face
Hinge Cover Name Plate
#1 Screw -
Adjust Left to Right
#3 Screw -
Adjust
Front to Back
#2 Screw -
Adjust
Top to Bottom
Blum Hinge Adjustment
Place Hinge Cover Name Plates on hinges
after adjustments are completed.
Hinge Toe Plate
1) Insert into
Hinge Toe
first
Hinge Plate
2) Lift and snap
into place
Door with Hinge
Hinge Plate* Factory Installed.
*If the door binds and does not fully
close, adjust the Hinge Plate on the
cabinet up and down, to relieve the
tension
Corner Protectors
Door Installation
The doors are packed individually for protection of
the mirror surfaces. Carefully remove the door
from the carton.* Hold the door in the upright po-
sition snap open the factory installed hinges.
Place the hinge onto the factory-installed mount-
ing plate in the cabinet -- Toe rst -- and snap into
position. Be careful not to chip the door mirror.
*Do not remove corner protectors until the door is
installed
To view a video showing helpful tips on how to adjust our cabinet
hinges, please go to GlassCraftersMirroredCabinets.com and navi-
gate to the cabinet product that you are installing. Simply click on
the installation tab (located below the product images) to view our
installation videos.
Limit Clips
Limit Clips are provided should you need
to reduce the opening swing of the cabi-
net door from 170 degrees to 130 de-
grees (see top view) This will eliminate
the possibility of the door hitting a wall
sconce or other decorative items.
Rececess Cabinet Door Swing Diagrams
Finished surface
Finished surface
Cabinet
Cabinet
170º swing
130º swing