Installation

below the hinge plates (as shown). Do not overtighten.
Cover screws with four screw caps (part #434).
D. Place the VTS spacer on the top front of the bottom
cabinet. Test t the top cabinet. Check that it is plumb and
level.
E. Clean the top of the base cabinet to insure that the
spacer tape will rmly adhere. Remove tape covering and
attach spacer to the bottom cabinet. (DO NOT REMOVE
THE TAPE COVER FOR THE TOP UNIT UNTIL YOU
TEST FIT AGAIN.)
F. Remove the top tape covering and re-install the cabi-
net and attach in place on the spacer. Make sure that the
VTS Spacer ts properly between the top and bottom
Cabinets.Fix to the the studs with four (4) #10 x 1 1/2”
wood screws (supplied).
Installing a
Recessed & Semi-Recessed
Mirrored Cabinet
A. Determine the rough opening for the cabinet. Refer to
“R.O.” formula chart on page 3. Opening must be plumb
and level.
B. Cabinet can be hinged on left or right. Simply ip the
cabinet to change hinge location. For multiple cabinet
units determine the hinge location for each unit before
they are joined together and mark the top of each unit.
C. Insert Bottom cabinet in R.O. and center, Cabinet
Flange covers any space in the R.O. around the cabinet
and should cover the nished surfaces--Sheetrock and/or
tile.
Install the cabinet with four (4) #10 x 1 1/2” wood
screws (supplied). Use the pre-punched holes above and
4