Manual

Glastender, Inc. • 5400 North Michigan Road • Saginaw, MI • 48604-9780
800.748.0423 • 989.752.4275 • Fax [phone] • www.glastender.com
17
cleanInG InsTrucTIons
The following cleaning instructions are recommended. Operating procedures of an establishment may alter the
time of cleaning and the personnel assigned to cleaning.
At the close of business, and after all glasses have been washed and unloaded, turn the Conveyor Switch and the
Fill Switch to the “off” position. No other attention is required until the next morning.
In the morning, the bartender should follow the recommended cleaning instructions. The bartender is respon-
sible for the drink quality of the establishment. Since drink quality includes clean glassware, knowledge of the
glasswasher is important.
sTep-by-sTep InsTrucTIons
1. Remove the Front Shield.
2. Position Glass Stop Arm past the Conveyor.
3. Removing the Front Curtain(s). (Note the two attachment tabs.)
4. Remove Conveyor.
5. Turn the Fill Switch to the “on” position to insure that the Wash and Rinse Tanks are full.
6. Turn the Conveyor Switch to the “on” position for as long as necessary to check the 15 nozzles in the Wash Spray
Box and the five (5) nozzles in the Final Rinse and Sanitize Spray Box for a uniform spray pattern.
7. Turn the Conveyor Switch and Fill Switch to the “off” position.
8. Remove Drain Plugs to drain tank.
9. Remove Rinse Tank Guide.
10. See which condition listed below best fits the unit. Then follow the suggested procedures.
condITIon descrIpTIon commenT procedure
LIGHT Moderate debris in tanks This unit is receiving proper Follow LIGHT
(straws, garnishes, etc.). user maintenance. All personnel procedures on
All spray nozzles are should be congratulated for doing next page.
functioning. a good job.
MEDIUM Light film in Wash Tank. This condition shows you were Follow MEDIUM
Considerable debris in the were busy last night, or proper procedures on the
tanks (straws, garnishes, maintenance has been neglected. next page.
and/ or broken glass, etc.).
Possible plugged spray
nozzle(s).
HEAVY Light to heavy white chalky Unit has been neglected. Install Follow HEAVY
substance (herein after referred proper maintenance procedures procedures on
to as “lime”) completely covers immediately. Caution: If the the next page.
the Wash Tank and components, unit operates in this condition,
especially the Heater. Excessive Heater and Recirculating Pump
debris in the tanks (straws, failures may result.
garnishes, broken glass, etc.).
Plugged spray nozzles.