User Manual

1
Glastender, Inc. • 5400 North Michigan Road • Saginaw, MI • 48604-9780
800.748.0423 • 989.752.4275 • Fax [phone] • www.glastender.com
IMPORTANT !! Attention Service Companies IMPORTANT !!
Please review the important warranty information on page 10. If you believe a service call should be covered
by the factory, please call the factory for authorization between 8AM and 5PM EST, Monday through Friday.
Topic Page
Digital Controller Operation ..................................................................................... 1
Utility Requirements and Connections ..................................................................... 2
Uncrating and Start-up Instructions .......................................................................... 2
Cleaning Instructions ................................................................................................ 2
Wall Mounting Instructions ...................................................................................... 3
Electrical and Refrigeration Specifications .............................................................. 4
Electrical Diagram .................................................................................................... 4
Replacement Parts ..................................................................................................5-6
Condenser and Related Parts .................................................................................7-8
Terms and Conditions .............................................................................................. 9
Warranty .................................................................................................................. 10
index
digitaL controLLer operation
Factory Settings Range of Adjustment
Set Point Operating Range† Minimum Set Point Maximum Set Point
Standard Cooler Setting
34º F 34º F to 39º F 33º F 35º F
† Adjusting the factory set point will also adjust the operating range by the same amount
The lettuce crisper is programmed to automatically defrost four
times daily for approximately twenty minutes. During defrost,
the fan inside the cooler will remain on and the refrigeration
system will turn off. To initiate defrost manually, push and hold
the DEFROST button for more than two seconds.
The thermostat controller does not have an “OFF” function. To
turn the lettuce crisper off, the unit must be unplugged or power
to the electrical branch circuit has to be turned off via a circuit
breaker or switch.
The operating temperature range is preset at the factory
according to the table below and can be adjusted up or down
within the limits shown.
To see the set point - push and immediately release the SET
button. The set point will be displayed.
To return to normal visualization - Push and immediately
release the SET button or wait ve seconds.
To change the set point - push and hold the SET button for
more than two seconds. When the º F display begins ashing,
push the up arrow or down arrow buttons to adjust the set point
to the desired value.
To save the new set point and return to the temperature
display mode - push and release the SET button or wait ten
seconds.