SDS

Glaze ‘N Seal Paver Sealer
Glaze ‘N Seal Page 4 of 7
7.2 Storage and Handling Practices:
Keep away from incompatible materials.
7.3 Specific Uses:
See Section 1.2.
SECTION 8 - EXPOSURE CONTROL/PERSONAL PROTECTION
8.1 Exposure Parameters:
Ingredients CAS No. ACGIH TLV OSHA PEL NIOSH PEL
Water 7732-18-5 Not Listed Not Listed Not Listed
Ethylene glycol 107-21-1 100 mg/m
3
100 mg/m
3
100 mg/m
3
8.2 Exposure Controls:
Ventilation and Engineering Controls:
Use with adequate ventilation to ensure exposure levels are
maintained below the limits provided above.
The following information on appropriate Personal Protective Equipment is provided to assist employers in complying with OSHA
regulations found in 29 CFR Subpart I (beginning at 1910.132), or standards of EU member states (including EN 149 for respiratory PPE,
and EN 166 for face/eye protection), and those of Japan. Please reference applicable regulations and standards for relevant details.
Respiratory Protection:
Not required for properly ventilated areas.
Maintain airborne contaminant concentrations below guidelines listed above, if
applicable. If necessary, use only respiratory protection authorized in the U.S.
Federal OSHA Respiratory Protection Standard (29 CFR 1910.134),
equivalent U.S. State standards, Canadian CSA Standard Z94.4-93, the
European Standard EN149, or EU member states.
Eye Protection:
Safety glasses or goggles are required.
If necessary, refer to U.S. OSHA 29 CFR 1910.133, Canadian Standards, and
the European Standard EN166, Australian Standards, or relevant Japanese
Standards.
Hand Protection:
Chemical resistant gloves are required to prevent skin contact.
If necessary, refer to U.S. OSHA 29 CFR 1910.138, the European Standard
DIN EN 374, the appropriate Standards of Canada, Australian
Standards, or relevant Japanese Standards.
Body Protection:
Use body protect appropriate to task being performed.
If necessary, refer to appropriate Standards of Canada, or appropriate
Standards of the EU, Australian Standards, or relevant Japanese Standards. If
a hazard of injury to the feet exists due to falling objects, rolling objects, where
objects may pierce the soles of the feet or
where employee’s feet may be exposed to electrical hazards, use foot
protection, as described in U.S. OSHA 29 CFR 1910.136.
SECTION 9 - PHYSICAL AND CHEMICAL PROPERTIES
9.1 Information on Basic Physical and Chemical Properties:
Appearance (Physical State and Color): Milky liquid
Odor: Ammonia odor
Odor Threshold: No data available
pH: 8.5
Melting/Freezing Point: No data available
Boiling Point: No data available
Flash Point: No data available
Evaporation Rate: No data available
Flammability (Solid; Gas): Not applicable
Upper/Lower Flammability or Explosion Limits: No data available
Vapor Pressure (mm Hg @ 20°C (68° F): No data available
Vapor Density: No data available