SDS

Glaze ‘N Seal Extra Strength “Natural Look” Penetrating Sealer
Glaze ‘N Seal Products, Inc. Extra Strength “Natural Look” Penetrating Sealer 180
Page 3 of 7
NFPA RATING SYSTEM
Flammability
Health Reactivity
Other
HMIS RATING SYSTEM
HAZARDOUS MATERIAL IDENTIFICATION SYSTEM
HEALTH HAZARD (BLUE) 1
FLAMMABILITY HAZARD (RED) 0
PHYSICAL HAZARD (YELLOW) 0
PROTECTIVE EQUIPMENT
EYES RESPIRATORY HANDS BODY
See Sect 8
See Sect
8
For Routine Industrial Use and Handling Applications
Hazard Scale: 0 = Minimum 1 = Slight 2 = Moderate 3 = Serious 4 = Severe * = Chronic Hazard
SECTION 6 - ACCIDENTAL RELEASE MEASURES (STEPS FOR SPILLS)
6.1 Personal Precautions, Protective Equipment and Emergency Procedures:
Use cautious judgment when cleaning up spill. Wear suitable protective clothing, gloves, and eye/face protection.
6.2 Environmental Precautions:
Construct a dike to prevent spreading. Keep out of sewers, storm drains, surface waters, and soils.
6.3 Spill and Leak Response:
Small Spills:
 Collect material via broom or mop. Place in tightly sealed containers for
proper disposal.
Large Spills:
 Approach spill areas with caution.
 If liquid was introduced, create a dike o
r trench to contain material. Soak up
with absorbent material such as clay, sand or other suitable non-reactive
material.
 Place in leak-proof containers. Seal tightly for proper disposal.
 Dispose of in accordance with U.S. Federal, State, and local hazardous
waste disposal regulations and those of Canada and its Provinces, those
of Australia, Japan and EU Member States (see Section 13, Disposal
Considerations).
SECTION 7 - HANDLING AND STORAGE
7.1 Precautions for Safe Handling:
To prevent eye contact under the foreseeable conditions of use, wear appropriate safety eyewear. When handling, do not eat, drink, or
smoke. Wash thoroughly after handling.
7.2 Storage and Handling Practices:
No data available
7.3 Specific Uses:
See Section 1.2.
SECTION 8 - EXPOSURE CONTROL/PERSONAL PROTECTION
8.1 Exposure Parameters:
No data available
8.2 Exposure Controls:
Ventilation and Engineering Controls:
Use with adequate ventilation to ensure exposure levels are
maintained below the limits provided above.
0
-
0
1