SDS

Glaze ‘N Seal Neutralizing Rinse
Glaze ‘N Seal Products, Inc. Neutralizing Rinse 330 Page 2 of 7
Prevention Statements:
P264 Wash thoroughly after handling.
P260 Do not breath dust/fume/gas/mists/vapours/spray.
P270 Do not eat, drink or smoke when using this product.
P271 Use only outdoors or in a well-ventilated area.
P280 Wear protective gloves/protective clothing/eye protection/face
protection.
Response Statements:
P301+P330+P331 IF SWALLOWED: Rinse mouth. Do NOT induce vomiting.
P303+P361+P353 IF ON SKIN (or hair): Take off immediately all
contaminated clothing. Rinse skin with water or shower.
P363 Wash contaminated clothing before reuse.
P304+P340 IF INHALED: Remove person to fresh air and keep comfortable
for breathing.
P310 Immediately call a POISON Center/doctor.
P321 Specific treatment (see section 4 on this SDS).
P305+P351+P338 IF IN EYES: Rinse cautiously with water for several
minutes. Remove contact lenses, if present and easy to do. Continue rinsing.
Storage Statements:
P405 Store locked up.
Disposal Statements:
P501 Dispose of contents/container in accordance with
local/regional/national/international regulations.
2.3 Health Hazards or Risks From Exposure:
Symptoms of Overexposure by Route of Exposure:
The most significant routes of overexposure for this product are by contact with skin or eyes. The symptoms of overexposure are
described in the following paragraphs.
Acute:
Inhalation: May cause respiratory irritation.
Skin Contact: Corrosive, may cause skin burns.
Eye Contact: Corrosive, may cause damage to the eyes.
Ingestion: May be harmful if swallowed.
Chronic: Repeated exposure may cause skin dryness or cracking.
Target Organs:
Acute: Eyes, Skin
Chronic: Skin
SECTION 3 - COMPOSITION / INFORMATION ON INGREDIENTS
Hazardous Ingredients: WT% CAS No. EINECS No. Hazard Classification
Sodium Metasilicate 5% 6834-92-0 014-010-00-8 Skin Corr Cat 1B, STOT SE Cat 3 (Resp. Irrit.)
Balance of other ingredients are non-hazardous or less than 1% in concentration (or 0.1% for carcinogens, reproductive toxins, or respiratory sensitizers).
Note: All WHMIS required information is included in appropriate sections based on the WHMIS 2015. This product has been classified in accordance with
the hazard criteria of the CPR and the MSDS contains all the information required by the CPR and EU Directives.
SECTION 4 - FIRST AID MEASURES
4.1 Description of First Aid Measures:
Eye Contact:
If product enters the eyes, flush with plenty of water or eye wash solution for
several minutes. Remove contacts if present and easy to do. Seek medical
attention if irritation persists.
Skin Contact:
Wash skin thoroughly with soap and water after handling. Seek medical
attention if irritation develops and persists.
Inhalation:
If breathing becomes difficult, remove victim to fresh air. If necessary, use
artificial respiration to support vital functions. Seek medical attention.
Ingestion:
If product is swallowed, call physician or poison center immediately. If
professional advice is not available, do not induce vomiting. Never induce
vomiting or give diluents (milk or water) to someone who is unconscious,
having convulsions, or who cannot swallow. Seek medical advice. Take a
copy of the label and/or SDS with the victim to the health professional.
Medical Conditions Generally Aggravated by
Exposure:
Pre-existing skin or eye problems may be aggravated by prolonged contact.