Use and Care Manual

NEUTRALIZING
RINSE & CLEANER
®
NEUTRALIZES ACID WASHED SURFACES PRIOR
TO SEALING. GENERAL PURPOSE CLEANER.
PRODUCT DESCRIPTION
Glaze ’n Seal Neutralizing Rinse and Cleaner is
an easy, safe way to neutralize harmful acid residue from
common surfaces before sealing. The benefit is the sealer
will bond better to the surface, reducing the likelihood of
sealer failure.
USES
Use on all Concrete, Brick, Tile, Stone and Masonry when
acid has been previously used in cleaning or etching process.
It may also be used as an alkaline cleaner for soil removal.
FEATURES
• Prevents acid/sealer failures
• Makes up to 10 gallons of solution
• Effective cleaner
• Phosphate free. Environmentally responsible
APPLICATION PROCEDURE
AS NEUTRALIZER
1. Dissolve 3-5 ounces per gallon of warm water. (For large
project, 1/2 container per 5 gallons of water).
2. Flood surface or apply liberally.
3. Allow to stand 1-5 minutes.
4. If necessary, surface may be scrubbed to remove any
stubborn stains.
5. Remove with wet vac, mop or sponge.
6. Thoroughly rinse with clean water.
7. Allow surface to dry (at least 24 hours) before sealing.
®
Quality Products for Concrete, Tile and Masonry
Glaze ’N Seal Products, Irvine, CA
FS 33-3/03
APPLICATION PROCEDURE
AS CLEANER
1. Dissolve 8-10 ounces per gallon of water.
2. Apply to surface.
3. Scrub to remove stubborn stains.
4. Remove solution, rinse and dry.
OTHER USES
When using acid, the acid rinse water can be neutralized
by adding Neutralizing Rinse prior to septic or sewer
disposal.
CAUTIONS
Contains sodium carbonate and sodium sesquicarbonate.
Avoid contact with eyes and prolonged contact with skin.
In case of eye contact, flush freely with water. If swallowed,
give water and call a physician.