SDS

Glaze ‘N Seal “Wet Look” Green
Glaze ‘N Seal Products, Inc. “Wet Look” Green 110 Page 5 of 8
SECTION 8 - EXPOSURE CONTROL/PERSONAL PROTECTION
8.1 Exposure Parameters:
Ingredients
CAS No.
ACGIH TLV
OSHA PEL
NIOSH PEL
p-Chloro-a,a,a-
triflourotoluene
98-56-6
100 mg/m
3
100 mg/m
3
100 mg/m
3
Acetone
67-64-1
500 ppm
1000 ppm
2400 mg/m
3
250 ppm
590 mg/m
3
Xylene
1330-20-7
100 ppm
500 ppm
2900 mg/m
3
500 ppm
2900 mg/m
3
Ethyl Benzene
100-41-4
20 ppm
100 ppm
435 mg/m
3
100 ppm
435 mg/m
3
8.2 Exposure Controls:
Ventilation and Engineering Controls:
Use with adequate ventilation to ensure exposure levels are
maintained below the limits provided above.
The following information on appropriate Personal Protective Equipment is provided to assist employers in complying with OSHA
regulations found in 29 CFR Subpart I (beginning at 1910.132), or standards of EU member states (including EN 149 for respiratory PPE,
and EN 166 for face/eye protection), and those of Japan. Please reference applicable regulations and standards for relevant details.
Respiratory Protection:
Not required for properly ventilated areas.
Maintain airborne contaminant concentrations below guidelines listed above, if
applicable. If necessary, use only respiratory protection authorized in the U.S.
Federal OSHA Respiratory Protection Standard (29 CFR 1910.134),
equivalent U.S. State standards, Canadian CSA Standard Z94.4-93, the
European Standard EN149, or EU member states.
Eye Protection:
Safety glasses or goggles are required.
If necessary, refer to U.S. OSHA 29 CFR 1910.133, Canadian Standards, and
the European Standard EN166, Australian Standards, or relevant Japanese
Standards.
Hand Protection:
Chemical resistant gloves are required to prevent skin contact.
If necessary, refer to U.S. OSHA 29 CFR 1910.138, the European Standard
DIN EN 374, the appropriate Standards of Canada, Australian
Standards, or relevant Japanese Standards.
Body Protection:
Use body protect appropriate to task being performed.
If necessary, refer to appropriate Standards of Canada, or appropriate
Standards of the EU, Australian Standards, or relevant Japanese Standards. If
a hazard of injury to the feet exists due to falling objects, rolling objects, where
objects may pierce the soles of the feet or where employee’s feet may be
exposed to electrical hazards, use foot protection, as described in U.S. OSHA
29 CFR 1910.136.
SECTION 9 - PHYSICAL AND CHEMICAL PROPERTIES
9.1 Information on Basic Physical and Chemical Properties:
Appearance (Physical State and Color): Clear liquid
Odor: Characteristic odor
Odor Threshold: No data available
pH: No data available
Melting/Freezing Point: No data available
Boiling Point: 55°C (131° F)
Flash Point: 1.67°C (35.01 F)
Evaporation Rate: No data available
Flammability (Solid; Gas): Not applicable