Glem - User Manual

ductwork sections.
INSTALL ELECTRICAL
Electrical wiring must be done by a qualified person(s) in accordance with
all applicable codes and standards. This range hood must be properly
grounded. Turn off electrical power at service entrance before wiring.
If the supply cord is damaged, it must be replaced by the manufacturer, its
service agent or similarly qualified persons in order to avoid a hazard.
INSTALL THE HOOD
Note 1 : On stainless steel hoods, carefully remove the plastic protective
film from all exterior surfaces of the hood and chimney prior to final
installation.
Note 2: At least two people will be required to mount the hood.
INSTALL THE HOOD
Minimum hood distance above the cooker
must not be less than 650mm.
A maximum of 750mm above the cooker is
highly recommended for best capture of
cooking impurities.
Distance over 750mm above the cooker are
at the installer’s and user’s discretion -
providing that ceiling height and flue length
permit.
1. Secure the hood mounting bracket to the
wall using
(3) ST 5 x 45mm mounting screws and dry wall anchors. Align
the hood body with the hood mounting bracket. Gently lower the hood
until it securely engages the bracket.
2. Fix the discharge collar into the air outlet adapter.
3. Attach an adequate length of 150mm round duct to the air outlet
adapter
(if have).
4. Carefully slide the decorative chimney top down inside the decorative