BE814 Fully Integrated Freezer INSTALLATION AND USER INSTRUCTIONS You must read these instructions prior to using the appliance and retain them for future reference.
Contents Introduction & safety warnings...........................................................................2 Electrical requirements ......................................................................................3 Transportation instructions.................................................................................4 Installation instructions.......................................................................................5 Repositioning the door .....................................
Congratulations on your choice of a Belling quality Appliance which has been designed to give you service for many years. WARNING ! IMPORTANT ! DO NOT connect your appliance to the electricity supply until all packing and transit protectors have been removed. • Leave to stand for at least 4 hours before switching on to allow compressor oil to settle if transported horizontally.
ELECTRICAL REQUIREMENTS Before you insert the plug into the wall socket make sure that the voltage and the frequency shown in the rating plate inside the appliance corresponds to your electricity supply. Rating label is on the left hand side of freezer inner liner. We recommend that this appliance is connected to the mains supply via a suitable switched and fused socket in a readily accessible position.
TRANSPORTATION INSTRUCTIONS 1. The appliance should be transported only in a vertical upright position. The packing as supplied must be intact during transportation. 2. If during the course of transport the appliance has to be transported horizontally, it must only be laid on its left hand side when standing in the front of the appliance. After bringing it to upright position,it must not be operated for at least 4 hours to allow the system to settle. 3.
IMPORTANT INSTALLATION INSTRUCTIONS 1. To avoid a hazard due to instability of the appliance, it must be fixed in accordance with the instructions. 2. Do not operate this appliance unless installed to furniture. 3. The appliance should be located on a smooth surface. The four front and back feet can be adjusted as required. To ensure that, your appliance is standing upright adjust the four front and back feet by turning clockwise or anti-clockwise, until the product is in firm contact with the floor.
REPOSITIONING THE DOOR Follow the step by step instructions and the diagram below. Numbers in brackets refer to diagrams.
1. Switch off at the socket outlet and pull out the mains plug. 2. Remove all food, loose items and fittings from inside the appliance and door shelves. 3. Unscrew the bolts and remove the upper and bottom hinges from the cabinet and door. (1) (2) 4. Remove stoppers. (3) (4) 5. Fit the stoppers on the opposite side. (5) (6) 6. Reposition the upper hinge on the opposite side as bottom hinge (7) 7. Reposition the bottom hinge on the opposite side as upper hinge.
STARTING Final Check Before you start using the freezer check that: 1. The feet have been adjusted and the product is level. 2. The interior is dry and air can circulate freely at the rear. 3. Clean the interior as recommended under "CLEANING AND CARE." 4. Insert the plug into the wall socket and switch on the electricity supply. Avoid accidental disconnection by taping over the switch. 5. You will hear a noise as the compressor starts up.
TEMPERATURE CONTROL AND ADJUSTMENT There are three coloured indicator lights located inside the appliance which show the operating mode of the freezer. Green Indicator (1) Illuminates when the appliance is connected to the mains and will glow as long as there is electricity present. The green light will not glow if the thermostat is set in the 'O' position. The green indicator does not give any indication of the temperature inside the freezer.
FREEZING FRESH FOOD Freezing capacity of your appliance in a 24 hours period is 10 kg (22.1 lb). Never exceed this maximum capacity. Fast freeze compartment (3) is shown in diagram. Take special care not to mix already frozen food and fresh food. If the fast freeze compartment (3) is filled with fresh food, other compartments can also be used to freeze fresh food. 1 2 2 1. Fast-freeze compartment 2.
DEFROSTING Defrost twice a year or when a frost layer of around 7 mm (1/4") has formed. To start defrosting procedure turn the thermostat knob to zero position (Alternatively you may switch off the freezer at the socket outlet and pull out the mains plug.) All food should be wrapped in several layers of newspaper and stored in a cool place (e.g. fridge or larder). Remove all freezer drawers.The special defrost collection basin collects the defrost water. Therefore defrosting can be conducted without mess.
CLEANING AND CARE ** We recommend that you switch off the freezer at the socket outlet and pull out the mains plug before cleaning. ** Never use any sharp abrasive instrument, soap, household cleaner, detergent and wax polish for cleaning. ** Use luke warm water to clean the cabinet of the freezer and wipe it dry. ** Use a damp cloth wrung out in a solution of one teaspoon of bicarbonate of soda to one pint of water to clean the interior and wipe it dry.
DO'S AND DON'TS Do- Check contents of the freezer at regular intervals. Do- Clean and defrost your freezer regularly (See "Defrosting") Do- Keep food for as short a time as possible and adhere to "Best Before", "Use By" dates. Do- Store commercially frozen food in accordance with the instructions given on the packets that you buy. Do- Always choose high quality fresh food and be sure it is thoroughly clean before you freeze it. Do- Prepare fresh food for freezing in small portions to ensure rapid freezing.
INSTALLATION INSTRUCTIONS - DETAILED STEP BY STEP 598 545 A 595 A (mm) 813 - 863 mm B (mm) 820 - 870 mm C (mm) 100 - 150 mm NOTE 1) Height of the product can be adjusted by the help of adjustable feet (front and back) to fit the furniture niche height (B). 2) Do not operate this appliance until it has been installed in the furniture.
0 0 C=100-150 mm 600 600 D C min. C min.55 C B min.55 D > 150 mm.
3 4 5 2 7 1 4 3 5 16 6 6
E = 1,5 mm is recommended. Top view E B = 25 mm minimum. B Front view E = = B 320 20 8 9 20 Note: 1. These dimensions are valid for products,which are hinged on right hand side. 2. When door opening direction is reversed, mirror image of this instruction should be considered. That is, dimensions should be considered for opposite sides.
10 11 12 13 14 18
15 19
GUARANTEE DETAILS Your new Belling product is guaranteed against the cost of breakdown repairs for twelve months from the date of the original purchase. What is covered? • Repairs necessary as a result of faulty materials, defective components or manufacturing defect. • The cost of functional replacement parts, but excluding consumable items. • The labour costs of a Belling approved repairer to carry out the repair. What is not covered? • Transit, delivery or accidental damage or misuse and abuse.
problem solving section Recycling This product bears the selective sorting symbol for waste electrical and electronic equipment (WEEE). This means that this product must be handled pursuant to European Directive 2002/96/EC in order to be recycled or dismantled to minimize its impact on the environment. For further information, please contact your local or regional authorities.
Technical data Fully Integrated Freezer BE814 PERFORMANCE Energy efficiency class A Energy consumption - Kwh/year 205 Net storage - vol fresh food ltrs (cu.ft.) ----- Net storage - vol frozen food ltrs (cu.ft) 87 (3.1) Total net vol - ltrs (cu.ft.) 87 (3.1) Frozen food compartment rating 4 STAR Conservation time from failure 19 hrs. Freezing capacity fresh food - kg /24 hrs.
WIRING DIAGRAM 23
BELLING CUSTOMER CARE In case of difficulty within the UK, please call Belling Customer Care Centre Helpline on 0844 815 3746 When you dial this number you will hear a recorded message and be given a number of options. This indicates that your call has been accepted and is being held in a queue. Calls are answered in strict rotation as our Customer Care Representatives become available.