Users Guide & Installation Handbook Belling CTC60 Hob 08 27451 01 @ 11.
19
Service Contents Calling for Service Please consult your retailer in the first instance. If you experience difficulty contact Belling Appliances, After Sales Division. Remember that you may be charged for the visit (even during the guarantee period) if nothing is found to be wrong with the appliance, so always check the instructions to make sure that you have not missed anything. Introduction 3 Installing Your Hob…..
Care of Your Hob Introduction Your Belling Hob Thank you for purchasing a new Belling electric built-in hob. Its stylish and practical design will enhance your kitchen and make cooking a pleasure. Even if you have used an electric hob before, it is important that you read these instructions thoroughly before starting to cook, paying particular attention to the installation and safety instructions.
Installing your hob Boost Function The hob features a boost facility which enables pans to be brought up to temperature quickly with maximum power, before dropping to a lower energy setting automatically. It is activated as follows, To Activate Boost Function 1. Switch on hob, as described previously. Touch pad repeatedly until 9. appears. The dot indicates that the boost function is activated. 2. Touch pad to reduce energy level to desired cooking energy level.
Installing your hob Connecting the hob Safety Features The connection to the electrical supply must be made before fitting the hob in the work top. For your own safety, we recommend that your hob is connected by a competent electrician. The installation must comply with current I.E.E. Wiring Regulations. It is possible to lock the element controls and timer against accidental operation. At any time during the hobs use, if the pad marked is touched for 2 seconds the controls will be locked i.e.
Timer Operation Installing your hob Your hob has a timer built in which can either be used to automatically switch off a cooking zone after a pre set period of time, or as an alarm reminder. The timer features a maximum duration of 99 minutes. Belling built-under single oven unit or double oven unit The hob can be fitted above a Belling built-under single or double oven unit if required. For your own safety, we recommend that your hob and oven are connected by a competent electrician.
For your safety Using A Ceramic Hob When used properly your Belling built-in hob is completely safe, but as with any electrical appliance there are some precautions you must take in its use. Controls Increase heat setting Never.. ● ● ● ● ● ● ● ● ● ● ● ● ● ● ● ● ● Element selector Never allow anyone except an authorised Belling Service Agent to service or repair your hob. Never remove any part of the hob other than those intended in normal use, or attempt to modify the appliance in any way.
Using A Ceramic Hob Using A Ceramic Hob WARNING: Extreme caution should be taken to avoid steam burns and hot surfaces when cleaning up spillage on the hot hob surface. 1. Always clean up any spillage immediately with a clean cloth or a paper towel to avoid unnecessary damage to the hob. 2. When cooking food which contains sugar (most food) or syrup, use a utensil which is large enough to prevent boil over or spillage.
Using A Ceramic Hob - Safety WARNING! If any crack should appear on the hob, isolate the hob immediately from the mains supply. Do not use any part of the hob but contact your Belling Service Agent. Using A Ceramic Hob – General Information NEVER The ceramic hob elements are fitted with special controls to regulate the element temperatures and to prevent overheating. The elements will be seen to switch on and off during use as the temperature is maintained automatically.
