MSDS

MATERIAL SAFETY DATA SHEET
The information contained herein is based on data available at the time of preparation of this data sheet which Akzo Nobel Paints believes to be reliable. However, no warranty is expressed or implied regarding the accuracy
of this data. Akzo Nobel Paints shall not be responsible for the use of this information, or of any product, method or apparatus mentioned and you must make your own determination of its suitability and completeness for
your own use, for the protection of the environment, and the health and safety of your employees and the users of this material.
Complies with OSHA hazard communication standard 29CFR1910.1200.
prepared 09/30/11
GLIDDEN PREMIUM DUO PAINT AND PRIMER IN ONE - EGGSHELL
GLD20XX
Akzo NobeI Paints 15885 Sprague Road Strongsville, Ohio 44136 EMERGENCY TELEPHONE NO. [phone]
HAZARDS IDENTIFICATION (ANSI Section 3)
Primary route(s) of exposure : Inhalation, skin contact, eye contact, ingestion.
Effects of overexposure :
Inhalation : Irritation of respiratory tract, lungs. Prolonged inhalation may lead to headache, nausea,
coughing, difficulty of breathing, severe lung irritation or damage.
Skin contact : Irritation of skin.
Eye contact : Irritation of eyes.
Ingestion : Ingestion may cause mouth and throat irritation, gastro-intestinal disturbances.
Medical conditions aggravated by exposure : Eye, skin, respiratory disorders, asthma-like
conditions.
FIRST-AID MEASURES (ANSI Section 4)
Inhalation : Remove to fresh air. Restore and support continued breathing. Get emergency medical
attention. Have trained person give oxygen if necessary. Get medical help for any breathing
difficulty. Remove to fresh air if inhalation causes eye watering, headaches, dizziness, or other
discomfort. Get medical attention if discomfort or irritation persists.
Skin contact : Wash thoroughly with soap and water. If any product remains, gently rub petroleum
jelly, vegetable or mineral/baby oil onto skin. Repeated applications may be needed. Remove
contaminated clothing. Wash contaminated clothing before re-use. If irritation occurs, consult a
physician.
Eye contact : Flush immediately with large amounts of water, especially under lids for at least 15
minutes. If irritation or other effects persist, obtain medical treatment.
Ingestion : If swallowed, obtain medical treatment immediately.
FIRE-FIGHTING MEASURES (ANSI Section 5)
Fire extinguishing media : Dry chemical or foam water fog. Carbon dioxide. Closed containers may
burst if exposed to extreme heat or fire. Easily ignited if allowed to dry. In closed tanks, water or
foam may cause frothing or eruption.
Fire fighting procedures : Water may be used to cool and protect exposed containers. Firefighters
should use full protective clothing, eye protection, and self-contained breathing apparatus.
Hazardous decomposition or combustion products : Carbon monoxide, carbon dioxide, monomer
vapors, acrylic monomers.
ACCIDENTAL RELEASE MEASURES (ANSI Section 6)
Steps to be taken in case material is released or spilled : Comply with all applicable health and
environmental regulations. Eliminate all sources of ignition. Ventilate area. Evacuate all unnecessary
personnel. Place collected material in proper container. Spilled material is extremely slippery.
Complete personal protective equipment must be used during cleanup. Large spills - shut off leak if
safe to do so. Dike and contain spill. Pump to storage or salvage vessels. Use absorbent to pick up
excess residue. Keep salvageable material and rinse water out of sewers and water courses. Small
spills - use absorbent to pick up residue and dispose of properly.
HANDLING AND STORAGE (ANSI Section 7)
Handling and storage : Store below 100f (38c). Keep from freezing.
Other precautions : Use only with adequate ventilation. Do not take internally. Keep out of reach of
children. Avoid contact with skin and eyes, and breathing of vapors. Wash hands thoroughly after
handling, especially before eating or smoking. Keep containers tightly closed and upright when not
in use. Avoid conditions which result in formation of inhalable particles such as spraying or abrading
(sanding) painted surfaces. If such conditions cannot be avoided, use appropriate respiratory
protection as directed under exposure controls/personal protection.
EXPOSURE CONTROLS/PERSONAL PROTECTION (ANSI Section 8)
Respiratory protection : Where respiratory protection is required, use only NIOSH/ MSHA approved
respirators in accordance with OSHA standard 29 CFR 1910.134.
Ventilation : Provide dilution ventilation or local exhaust to prevent build-up of vapors.
Personal protective equipment : Eye wash, safety shower, safety glasses or goggles. Impervious
gloves, impervious clothing. Replace elastomeric protective equipment whenever it becomes
swollen, gummy, torn, or shows evidence of barrier loss. Apply a solvent-resistant skin barrier cream
to areas of skin that may come into contact with material. If working out-of-doors, apply sunscreen
lotion with a high sun block protection factor to skin exposed to sunlight after applying barrier cream.
STABILITY AND REACTIVITY (ANSI Section 10)
Under normal conditions : Stable see section 5 fire fighting measures
Materials to avoid : Oxidizers, acids, hydrogen fluoride.
Conditions to avoid : Elevated temperatures, contact with oxidizing agent, freezing, sparks, open
flame, extremes in temperature.
Hazardous polymerization : Will not occur
TOXICOLOGICAL INFORMATION (ANSI Section 11)
Supplemental health information : No additional effects are anticipated
Carcinogenicity : The international agency for research on cancer (IARC) has classified titanium
dioxide as possibly carcinogenic to humans (group 2b) based on inadequate evidence of
carcinogenicity in humans and sufficient evidence of carcinogenicity in experimental animals.
Reproductive effects : No reproductive effects are anticipated
Mutagenicity : No mutagenic effects are anticipated
Teratogenicity : No teratogenic effects are anticipated
ECOLOGICAL INFORMATION (ANSI Section 12)
No ecological testing has been done by akzo nobel paints llc on this product as a whole.
DISPOSAL CONSIDERATIONS (ANSI Section 13)
Waste disposal : Dispose in accordance with all applicable regulations. Avoid discharge to natural
waters.
REGULATORY INFORMATION (ANSI Section 15)
As of the date of this MSDS, all of the components in this product are listed (or are otherwise exempt
from listing) on the TSCA inventory. This product has been classified in accordance with the hazard
criteria of the CPR (controlled products regulations) and the MSDS contains all the information
required by the CPR.