User's Manual

POV 100

PLEASE NOTE:

 For use with cameras weighing up to 2.5lbs or

1.15kg including the lens

 The POV100 comes in 2 sizes: M (54-60cm/21.25-

23.6”) and L (56-62cm/22-24.4”)

 Recommended use with wide angle lenses set to

innity focus for best results

For more informaon please visit our website: www.glidegear.net

Fig A

Mount your camera using the screw

inside the slot in the crossbar in the

front of the helmet. See Fig A.

Crossbar

Mounng

screw

Included with the POV 100 are 10 weight plates. With

the camera mounted in the front, your head will be

leaning forward. Add weight plates to the back of the

helmet to balance your head and ease the strain on

your neck. Use the supplied thumb nut to secure the

weight plates in an unloose posion. See Fig. B

Fig C

Hint: Weigh your camera and use the appropriate

number of plates to get as close as possible to the

camera weight knowing that 1 plate weighs about

4oz (or 100g).

Example: For a camera weighing 1.6lbs, add 6-7

plates to the back.

Thumb nut

In the rear inside of the helmet, you will nd a knob.

Use the knob to ghten or loosen the helmet’s inside

frame so that the helmet ts ghtly on your head.

The knob in queson is circled on Fig. C.

Fig B

PAGE 1
POV 100 1 PLEASE NOTE:  For use with cameras weighing up to 2.5lbs or 1.15kg including the lens  The POV100 comes in 2 sizes: M (54-60cm/21.2523.6”) and L (56-62cm/22-24.4”)  Recommended use with wide angle lenses set to infinity focus for best results Crossbar 2 3 Mount your camera using the screw inside the slot in the crossbar in the front of the helmet. See Fig A. Mounting screw Fig A Included with the POV 100 are 10 weight plates.
PAGE 2
POV 100 5 At this point, your setup should look like Fig. D. The POV 100 is a very flexible head rig with multiple adjustments and mounting possibilities. See the adjustments available below . Top Plate features:  1/4-20 female threaded holes to mount mic, lights, friction arm etc..  14/4-20 mounting screw to mount a GoPro, a 360 camera, light, mic, friction arm etc.. Front Plate features:  1/4-20 female threaded holes for accessories  14/4-20 mounting screw Temple Plate: Remove the 2 screws.
PAGE 3
POV 100 If any assembling is needed, please refer to the below section: Fig F Fig E BACK: Mount the plate with the longest FRONT: Mount the curved rectangular plate screw to the back of the helmet using 2 of the supplied M3 screws. Fig E. to the front of the helmet using 2 of the supplied M3 screws and through the 2 slots on the plate. Fig F.