Quick Start Guide

TMP100

Set the TMP100 on a at surface or use one of the several

mounng holes at its boom to mount it onto a tripod.

For more informaon please visit our website: www.glidegear.net

Setup

Release the screen by pulling on the upper pins

on both sides.

Extend the tray to place your tablet/phone on it.

Rotate the screen to set it at a 45-degree angle.

Use the boom pin on each side to lock the

screen into posion.

Mount the camera onto the back plate.

Cover lens with the black cloth aached to the

screen.

Adjust the posion of the camera so its lens is as

close as possible to the screen.

PAGE 1
TMP100 Setup 1 Set the TMP100 on a flat surface or use one of the several mounting holes at its bottom to mount it onto a tripod. 2 Extend the tray to place your tablet/phone on it. 3 4 Rotate the screen to set it at a 45-degree angle. 5 Use the bottom pin on each side to lock the screen into position. Release the screen by pulling on the upper pins on both sides. 6 Mount the camera onto the back plate. 7 Cover lens with the black cloth attached to the screen.
PAGE 2
TMP100 9 Install a teleprompter application on your cell phone or tablet. WARNING: Please note that the application must allow mirroring of text to be used with the TMP100. WARNING: The TMP100 does not come with an application for cell phone or tablet. 10 Type the speech in the application. Set the speed for the scrolling of the text. 11 Mirror the text in the application. 12 Place the tablet or cell phone on the tray of the TMP100.