User's Manual

16
Figure 32
Make sure the QUICK RELEASE PLATE is in
alignment square with the bottom of your Camera and
make sure the THREADED INSERT on the base of
your Camera is aligned with one of the MOUNTING
HOLES in the QUICK RELEASE PLATES.
(See Figure 32)
Figure 33
With your Camera base side up in your lap and with
the QUICK RELEASE PLATE in place, use a at head
screwdriver to secure the QUICK RELEASE PLATE
to your Camera using the CAMERA MOUNTING
SCREW.
(See Figure 33)
WARNING: Do not over tighten this screw. Over
tightening could break the THREADED INSERT
on your Camera.
Figure 34
If all is correct, the QUICK RELEASE PLATE should
now be securely fastened to your Camera.
(See Figure 34)
NOTE: If you can easily rotate the QUICK
RELEASE PLATE on the base of your Camera,
even though you have adequately tightened the
CAMERA MOUNTING SCREW, and you do not feel
comfortable tightening the CAMERA MOUNTING
SCREW any more, then you should think about
using some sort of a exible GASKET between
your Camera base and QUICK RELEASE PLATE.
You could use rubber tape, or a square at piece
of rubber (for example, creating one by cutting
up an old rubber dish washing glove)