User Manual

Figure 12
First, Get the BASE PLATFORM and the
TELESCOPING POST.
See Figures 7 and 12 for BASE PLATFORM &
Figures 8 and 13 for TELESCOPING POST.
#3 ASSEMBLING YOUR GLIDECAM
XR-SERIES
Figure 13
Note the threaded insert located in the bottom the of
TELESCOPING POST.
8 9
Note the threaded insert located in the bottom the of
TELESCOPING POST.
Figure 14
Figure 15
At this point your Glidecam XR-SERIES should look
like Figure 15 which is with the TELESCOPING
POST attached to the BASE PLATFORM.
Figure 16
Now nd a pair of bolts (example: ¼” x 20 x 1.5”) and
attach RUBBER WASHERS as shown in the photo
to the left. Other length bolts for more COUNTER
WEIGHT DISKS are available and can be used.
NOTE: Different length bolts are provided so you can use the
longer bolts for a taller stack of COUNTER WEIGHTS DISKS.
Figure 17
Now, insert the selected bolts (example ¼” x 20 x
1 1/2”) with RUBBER WASHERS bolts through the
slots in the BASE PLATFORM as shown in this
picture and repeat this procedure for the slot on the
other side of the BASE PLATFORM.