User Manual

Figure 18
At this point your Glidecam XR-SERIES
should look like this photo.
NOTE: This is the Monitor Mounting Hole
Figure 19
Stack LARGE COUNTER WEIGHT DISKS and
center them over the bolts on the BASE PLATFORM
as shown in Figure 19.
NOTE: Different length bolts are provided so you can use the
longer bolts for a taller stack of COUNTER WEIGHTS DISKS.
NOTE: Heavy Cameras require more COUNTER WEIGHT
DISKS than light Cameras.
Figure 20
Place SMALL WEIGHT DISKS over COUNTER
WEIGHT DISK stacks.
10 11
Figure 21
Secure COUNTER WEIGHT DISKS with the BLACK
THUMB NUTS as shown in this photo and repeat this
procedure for the COUNTER WEIGHT DISKS on the
other side of the BASE PLATFORM.
Figure 22
Both COUNTER WEIGHT DISK stacks should now
be secured in place with the SMALL COUNTER
WEIGHT DISKS and BLACK THUMB NUTS as
shown in this photo.
Figure 23
Now, insert the TELESCOPING POST and attached
BASE PLATFORM up and into the XR-SERIES
CENTRAL POST.
The TELESCOPING CLAMP should be facing the
backend of the BASE PLATFORM, opposite the
monitor mounting hole, which is in the front of the
BASE PLATFORM.
Monitor Mounting Hole
should be in front.
Telescoping Clamp’s
“Adjustment Knob”
Shown aligned
Incorrectly.
Telescoping Clamp’s
“Adjustment Knob”
should be in back.