Installation & Assembly

Installation Kit Instructions
Step 1
Decide the location of the cabinet hardware knob/pull you would like to install.
Step 2
Carefully measure and mark each hole location to the dimensions of your knob or pull.
Templates are pre-marked for 3”, 3.5”, 96mm, (3.75”) and 4”. For wider pulls, just measure
out from the center and move template left and right to the desired width.
Step 3
Using a 3/16” bit, carefully drill through the cabinet or drawer – using minimal pressure to
reduce splintering on the backside of the surface. To prevent damage while drilling, place
masking tape in the approximate hole location prior to measuring.
Step 4
Install your GlideRite cabinet hardware using a #2 Phillips screwdriver. Be careful not to
overtighten screws.
Tips
 You can raise the template by placing a strip of wood between the template and the
cabinet door or drawer.
 The 1-inch screw(s) included with your GlideRite hardware are adequate for most
3/4" doors and drawers; for thicker drawers, purchase #8-32 screws 1/4" longer
than the thickness of the drawer.
 Measure twice to assure cabinet hardware positioning.
 Mark all your holes first and then stand back and look at your cabinets to make sure
you have placed them where you want them before drilling.