Assembly Instruction BAR STOOL
PRE-ASSEMBLY PREPARATION • CARE AND CLEANING: DO NOT scratch or chip the finish. DO NOT use abrasive chemicals for cleaning. • MAINTENANCE: Check bolts/screws periodically and tighten them if necessary. • WARNING: DO NOT USE if this product become damaged, and/or components are broken or missing. • REMINDER: DO NOT fully tighten all bolts until assembly is completely finished.
STEP 1 Insert the Gas Lift (E) and Cap (F) to the Base (D) as shown below. E F Warning!!! Please remove the plastic cap before assembly. D STEP 2 Connect the Backrest (A) and Seat (B) by using Connection(G) by using Allen Bolt (H) and Allen Wrench (I).
STEP 3 Attach the Leg (C) to the back of Seat (B) by using Allen Bolt (H) and Allen Wrench (I). I C H B A STEP 4 Insert the Leg (C) to the Gas Lift (E) of the base part as shown below. After initial assembly, the product may acclimate to its new environment. Please unsure all screws are still securely tightened.