Assembly Instruction 4 TIER A FRAME BOOKCASE
PRE-ASSEMBLY PREPARATION WARNING: MAXIMUM LOAD NOT EXCEED 45LBS ON SHELVES. CAUTION: Assembly will require at least 2 adults. Assem any damage. DO NOT use power tools.
PARTS LIST Right upper frame (A) Right bottom frame (B) Qty: 1 Bottom cross bar (E) Qty: 1 Middle long shelf cross bar (F) Qty: 1 Bottom panel (I) Left upper frame (C) Qty: 1 Middle short shelf cross bar (G) Qty: 1 Middle long shelf panel (J) Qty: 1 Left bottom frame (D) Qty: 1 Top cross bar (H) Qty: 1 Qty: 1 Middle short shelf panel (K) Top panel (L) Qty: 1 Qty: 1 Qty: 1 HARDWARE LIST ALLEN BOLT (2) ALLEN BOLT (1) M6*10mm M6*30mm Qty: 8 ANTI-TIPPING STRIP (5) 5*200mm 4mm Qty: 24 WAL
REQUIRED HARDWARE IN THIS STEP NO. DESCRIPTION SKETCH QTY 1 ALLEN BOLT M6*10mm 8PCS 3 ALLEN WRENCH 1PC STEP 1 Attachright upper frame (A) on right bottom frame (B) with Allen bolts (1) and Allen wrench (3). Repeat this action for left upper Repeat this action for left upper (D). A A C B The 4 holes must be on the same side and align 1 D B REQUIRED HARDWARE IN THIS STEP NO.
REQUIRED HARDWARE IN THIS STEP NO. STEP 3 DESCRIPTION SKETCH QTY 2 ALLEN BOLT M6*30mm 8PCS 3 ALLEN WRENCH 1PC Attach top cross bar (H), middle short shelf cross bar (G), middle long shelf cross bar (F) and bottom cross bar (E) with allen bolt (2) using allen wrench (3). DO NOT fully tighten bolts until all cross bars are attached. H 2 H 2 2 G G 2 F 2 2 F E 2 E 2 REQUIRED HARDWARE IN THIS STEP NO.
REQUIRED HARDWARE IN THIS STEP NO. DESCRIPTION QTY 8 ALLEN BOLT M6*12mm 1PC 4 STEEL PLATE 1PC 3 STEP 5 SKETCH ALLEN WRENCH 1PC Attach steel plate (4) to the hole left open on the outside of the top frame with allen bolt (8) using allen wrench (3). REQUIRED HARDWARE IN THIS STEP DESCRIPTION NO. STEP 6 SKETCH QTY 4 STEEL PLATE 1 PC 5 ANTI-TIPPING STRIP 1 PC 6 WALL ANCHOR Ø 8.5*30mm 1 PC 7 PHILLIPS SCREW Ø 4*25mm 1 PC Place the shelves in the desired location.