Assembly Instruction WINE RACK
PRE-ASSEMBLY PREPARATION WARNING: MAXIMUM LOAD NOT EXCEED 55LBS ON SHELVES. • CAUTION: Assembly will require at least 2 adults. DO NOT use power tools.To prevent serious injury or death,this product is equipped with a wall anchoring system.Before this product can be used,the wall anchoring system must be installed as directed in the assembly instructions. • CARE AND CLEANING:DO NOT scratch or chip the finish.DO NOT use abrasive chemicals for cleaning. Clean with mild soap on a soft rag.
PARTS LIST TOP PANEL (A) SIDE PANEL (B) Qty: 1 FLAT SHELF (C) Qty: 2 WINE RACK SHELF (D) Qty: 1 Qty: 3 REINFORCED POLE (E) Qty: 1 HARDWARE LIST ALLEN BOLT (F) BOLT LOCK (G) M6*15mm PHILLIPS SCREW (H) Ø15*0.9mm Qty: 20 SCREWDRIVER (J) Qty: 20 ANTI-TIPPING STRIP (K) 5*270mm Qty: 1 Ø4*20mm Qty: 15 WALL ANCHOR (L) Ø8.
REQUIRED HARDWARE IN THIS STEP 1 & 2 NO. DESCRIPTION SKETCH QTY F ALLEN BOLT 20PCS G BOLT LOCK 20PCS I ALLEN WRENCH 1PC STEP 1 Attach 1 pc Side Panel (B) to the Top Panel (A), the Flat Shelf (C) and 3 pcs Wine Rack Shelves (D) by using 10 pcs Allen Bolt (F), 10 pcs Bolt Lock (G) and Allen Wrench (I). D D D C B A STEP 2 Attach 1 pc Side Panel (B) to the Top Panel (A), the Flat Shelf (C) and 3 pcs Wine Rack Shelves (D) by using 10 pcs Allen Bolt (F), 10 pcs Bolt Lock (G) and Allen Wrench (I).
REQUIRED HARDWARE IN THIS STEP 3 STEP 3 NO. DESCRIPTION SKETCH QTY H PHILLIPS SCREW 10PCS J SCREWDRIVER 1PC Using 10 pcs Phillips Screws (H) and Screwdriver (J) to fix the Side Panel (B), the Top Panel (A), the Flat Shelf (C) and 3 pcs Wine Rack Shelves (D) by two sides. A B REQUIRED HARDWARE IN THIS STEP 4 STEP 4 NO.
REQUIRED HARDWARE IN THIS STEP 5 NO. H DESCRIPTION SKETCH QTY 1PC PHILLIPS SCREW Ø4*20mm K 1PC ANTI-TIPPING STRIP L WALL ANCHOR Ø 8.5*30mm 1PC M PHILLIPS SCREW Ø 4*40mm 1PC N STEEL PLATE 2PCS J PHILLIPS SCREW DRIVER 1PC H NOT INCLUDED K L N NOT INCLUDED WALL M N WALL J K WALL STEP 5 Attach steel plate (N) to top panel (A) with screw (H) using screwdriver. Place assembled unit in desired position. Mark position of steel plate (N) on wall and remove unit.
STEP 6 6