Assembly Instruction PATIO WICKER SOFA SET
PRE-ASSEMBLY PREPARATION WARNING! DO NOT LET CHILDREN PLAY IN OR AROUND THE UNIT DUE TO THE POSSIBLE RISK OF FINGER ENTRAPMENT • Please read through this instruction before beginning assembly. • Two adults assembly is recommended. • Clear out the space for assembly and lay out all parts base on parts List, extra room will allow you to easily determine if all the pieces are present. • Save all packing materials until assembly is complete to avoid accidentally discarding smaller parts or hardware.
PANEL AND FITTINGS IDENTIFICATION Back Panel A1 Back Panel A2 With a hole here Qty: 2 Qty: 2 Ottoman Qty: 1 Back Panel A3 Qty: 2 Coffee Table Qty: 1 Seat Panel B1 Seat Panel B2 With a hole here Qty: 2 Seat Cushion Qty: 5 Qty: 2 Back Cushion Qty: 6 HARDWARE LIST Connector (C) Short Bolt (D) M6 X 15mm Qty: 4 Wrench (H) Qty: 1 Qty: 8 Plastic Clip (I) Qty: 6 Long Bolt (E) Washer (F) Plastic Cap (G) M6 X 35mm Qty: 20 Qty: 28 Qty: 28
W Step 1 Attach back panel A2 and A3 to seat panel B1 by using 6 long Bolts (E) and 6 Washers (F). Finally put bolt Caps (G) untl all parts have been connected and bolts are tightened. A2 A3 B1 Step 2 Connect the two back panels by using 2 Connectors (C), 4 short Bolts (D) and 4 Washers (F). Finally put bolt Caps (G) untl all parts have been connected and bolts are tightened. Repeat step 1 and 2 to assemble two corner sofa.
Step 3 Atach back panel A1 to seat panel B2 by using 4 long Bolts (E) and 4 Washers (F). Finally put bolt Caps (G) untl all parts have been connected and bolts are tightened. Repeat to assemble two armless sofa. F A1 E F E G G B2 Step 4 Connect the sectonal sofa with two plastc Clips (I) on each side.
Step 5 5 Finally put the cushions on. Coner sofa with two back cushions and armless sofa with one back cushions.
