Instructions / Assembly

ManualsBrandsGlitzhome ManualsFlood Lights8.25 in. L Black Outdoor Solar Powered Dual-Head SMD LED Motion Senser Security Flood Path Light

ASSEMBLY INSTRUCTION

Glitzhome, LLC

SOLAR DUAL HEAD SECURITY LIGHT

HOW THE SOLAR LIGHT WORKS:

During the day, the solar panel converts solar power into energy and stores it in the rechargeable battery. At night, the light

turns on automatically and using the energy stored when motion is detected. The duration of the illumination will depend on

your geographical location, weather conditions and seasonal light availability.

FEATURES

PASSIVE INFRARED (PIR) MOTION SENSOR:

1. Up to 8 meters and 120° detection range

2. Note: the vertical height of PIR sensor from the ground should be 1.8m to 2m.

SOLAR PANEL

1. Attach to 5cm cable length, your solar panel can be easily positioned in an area that will receive maximum sunlight each

day to fully charge the batteries.

2. The solar panel is an amorphous solar panel, which has a high shadow tolerance and is able to charge in cloudy

conditions. However, for optimum charge, the panel must be placed in an area that receives a maximum amount of direct

sunlight every day. It should be exposed to at least 8 hours of direct sunlight each day to fully charge the batteries.

3. Built-in photo sensor controls when your solar security light will begin to activate, according to the surrounding natural

light level.

CHOOSE AN IDEAL LOCATION:

1. Choose an outdoor location where the solar panel can receive at least 8 hours of full and direct sunlight each day.

Shaded locations will reduce the battery charge and shorten the operating time at night.

2. Avoid placing solar security light near bright light sources, such as street lights. The bright light sources may cause the

solar light to turn off automatically. Solar lights are ideal for night time lighting in the garden, lawn, etc. You can also place

the solar lights outdoor during the day and then place them indoor, garage, shed, corridor or caravans for lighting.

IMPORTANT: DOUBLE CHECK CONTENTS BEFORE DISCARDING THE PACKAGING TO

PREVENT LOSING PARTS THAT ARE NEEDED FOR ASSEMBLY

Summary of content (4 pages)

PAGE 1
Glitzhome, LLC ASSEMBLY INSTRUCTION SOLAR DUAL HEAD SECURITY LIGHT IMPORTANT: DOUBLE CHECK CONTENTS BEFORE DISCARDING THE PACKAGING TO PREVENT LOSING PARTS THAT ARE NEEDED FOR ASSEMBLY HOW THE SOLAR LIGHT WORKS: During the day, the solar panel converts solar power into energy and stores it in the rechargeable battery. At night, the light turns on automatically and using the energy stored when motion is detected.
PAGE 2
Glitzhome, LLC ASSEMBLY INSTRUCTION 3. When choosing a location, remember that there is 5m cable length attached to the solar panel, which means that your light can be installed anywhere within 5m of the chosen location for the solar panel. 4. When locating a suitable position for the device, remember that the PIR sensor detects an area of approximately 120 degrees horizontally within a range of up to 8 meters. 5. The recommended mounting height for your security light is approximately 2m. 6.
PAGE 3
Glitzhome, LLC ASSEMBLY INSTRUCTION SECURITY LIGHT INSTALLATION: Step 1: Choose a location for the light (A), remembering that it must be within a 5m distance to where you have installed the solar panel. Step 2: Use the drill template to mark drilling holes onto the mounting surface. Step 3: Remove template and drill holes at each of the 2 points marked and insert wall plugs (D) into each hole. Before drilling holes, it is recommended that you first check that the marks you have made are straight.
PAGE 4
Glitzhome, LLC ASSEMBLY INSTRUCTION TROUBLESHOOTING : If your solar security light does not turn on automatically when motion is detected at night after fully charged, please check the following: 1. Make sure the power switch is at the the "AUTO" position. 2. Check that the male plug attached to the solar panel has been connected securely to the light body to enable batteries to charge. 3. Batteries may need charging or replacing.