Instructions / Assembly

ASSEMBLY INSTRUCTION

Glitzhome, LLC

3. When choosing a location, remember that there is 5m cable length attached to the solar panel, which means that your

light can be installed anywhere within 5m of the chosen location for the solar panel.

4. When locating a suitable position for the device, remember that the PIR sensor detects an area of approximately 120

degrees horizontally within a range of up to 8 meters.

5. The recommended mounting height for your security light is approximately 2m.

6. Your security light should be located in a semi-protected area where it will not be exposed to excessive rain.

ASSEMBLY INSTRUCTIONS:

This pack should come complete with the following:

1 x solar security light (Part A)

1 x solar panel (Part B)

5 x mounting screws (Part C)

5 x wall plugs (Part D)

PRECAUTIONS BEFORE INSTALLATION

Select a preferred location for your security light and solar panel

At this point check to ensure:

1. The distance between the solar panel and security light is maximum 5 meters.

2. The position chosen for your solar panel is an area that will receive a maximum amount of full direct sunlight each day.

3. The location chosen for the security light is within the specified detection range to meet your security lighting needs,

e.g. close enough to an entrance way, garage door, etc, see figure 1.

SOLAR PANEL INSTALLATION:

Step 1: Hold solar panel (B) with wall mounting bracket against the mounting surface and place marks through the 3

mounting holes.

Step 2: Place solar panel down to one side and drill holes at each of the 3 points marked, large enough to fit the plastic wall

plugs (D) inside.

Step 3: Place plastic wall plugs into the holes. NOTE: IF YOU ARE INSTALLING PANEL ONTO A WOODEN SURFACE,

PLASTIC WALL PLUGS ARE NOT REQUIRED.

Step 4: Secure the solar panel mounting bracket onto the surface, by aligning the mounting holes with the 3 wall plugs

installed in step 3.

Step 5: Using a screwdriver, insert 3 screws (C) over the 3 mounting holes on the bracket and into the mounting surface,

and tighten to secure.

Step 6: Adjust the angle of the solar panel for maximum sun exposure.