Instructions / Assembly

ASSEMBLY INSTRUCTION

Glitzhome, LLC

SECURITY LIGHT INSTALLATION:

Step 1: Choose a location for the light (A), remembering that it must be within a 5m distance to where you have installed

the solar panel.

Step 2: Use the drill template to mark drilling holes onto the mounting surface.

Step 3: Remove template and drill holes at each of the 2 points marked and insert wall plugs (D) into each hole. Before

drilling holes, it is recommended that you first check that the marks you have made are straight. NOTE: IF YOU

ARE INSTALLING LIGHT BODY ONTO A WOODEN SURFACE, PLASTIC WALL PLUGS ARE NOT REQUIRED.

Step 4: Insert screws (C) into the wall plugs leaving approximately 5mm to project from the wall.

Step 5: Mount the light onto the wall by hooking the 2 keyholes at the back of the light over the screws installed in the

above step.

Step 6: Using a screwdriver and the adjustment screw located at the side of PIR housing, adjust the angle of the PIR sensor

so it is directed towards your detection area.

CONNECTING YOUR SOLAR SECURITY LIGHT AND SOLAR PANEL

Step 1: Locate the male plug attached to the 5m cable length on the solar panel.

Step 2: Locate the connection socket near the AUTO/OFF push button and connect the solar panel with the security light.

ATTENTION FOR FIRST TIME USE:

1. Keep the security light and solar panel connected, the batteries in your security light must be fully charged before the first

time to use. (Note: When you disconnected the security light and solar panel, the security light will light all the time until the

energy stored in the battery used up.)

2. To charge batteries, expose the solar panel to direct sunlight for 36-48hours, and at this point please ensure the

"AUTO/OFF" button is at the ''OFF'' position.

3. After you have fully charged the batteries, push the "AUTO/OFF" button to the ''AUTO'' position, it will automatically turn

on when motion is detected at night and automatically charge during the day.

4. Please note the solar light is designed to work when the environment gets dark. If there are strong light sources nearby,

the solar light may illuminate dimly or not light up at all.

5. Surface of the solar panel must be kept clean. Dusty surface will reduce charging efficiency.

90mm

DRILL TEMPLATE FOR

SOLAR LIGHE:

Horizontal level