Assembly Instruction PATIO LOVESEAT GLIDER CHAIR
PRE-ASSEMBLY PREPARATION WARNING! DO NOT LET CHILDREN PLAY IN OR AROUND THE UNIT DUE TO THE POSSIBLE RISK OF FINGER ENTRAPMENT • Please read through this instruction before beginning assembly. • Two adults assembly is recommended. • Clear out the space for assembly and lay out all parts base on Parts List, extra room will allow you to easily determine if all the pieces are present. • Save all packing materials until assembly is complete to avoid accidentally discarding smaller parts or hardware.
STEP-BY-STEP ASSEMBLY STEP 1 Attach 2 pc short end of Connecting Rods (F) to Base (E) with Washer (L) and Bolt (I). Save bolt cap (M) until all parts have been connected and add after final tightening. If this step is completed correctly, the long end of connector bar (F) should hang down as shown in assembly picture.
STEP 3 NOTE: When attaching the arms, insert screws in opposite order to ensure hole lineup, as follows, in an “X” pattern per arm.-Attach Right Armrest (A) and Left Armrest (B) to Back Panel (C) and Seat Panel (D) with Washer (L), Bolt (K), Bolt (J) and Bolt Cap (M); Save bolt cap (M) until all parts have been connected and add after final tightening. LK M L J M NOTE: Bolt K is used for the back arm assembly. Bolt J is used for the front arm assembly.
STEP 5 Now tighten all screwas using the locking wrench to ensure assembly is complete and secure. Once complete, use bolt cap(M) to cover all screw heads. STEP 6 Put on Seat Cushion (G) and Back Cushion (H). Please make sure all bolts are properly tightened before use.