User Guide

iTach IP Quick Start

Global Caché is doing our part

to lessen our carbon footprint by

providing recyclable packaging

and reducing our paper output.

For complete documentation

and tutorials, visit:

www.globalcache.com/docs

e quick start below will get

you started.

Getting Started.

Connect both an

RJ45 (Ethernet) network cable and

power supply to your iTach unit. If

the iTach is PoE (Power over Eth-

ernet) enabled, connecting a power

supply is not necessary. In its default

conguration, the iTach TCP/IP mod-

els use DHCP to automatically ob-

tain an IP address from your router.

To determine the iTach’s IP address,

download the iHelp application from

www.globalcache.com/docs.

Run iHelp on a Windows PC connect-

ed to your network. iHelp listens for

Global Caché multicast beacons and

displays the iTach IP address and other

details within one minute. If a DHCP

server is not present, defaulted iTach

units will reside at IP 192.168.1.70.

For IP2IR and IP2SL units the Infrared

and Serial settings should be set. Right

click on the unit and select Congure to

load the conguration pages to change

the iTach’s Infrared and Serial settings.

PAGE 1
iTach IP Quick Start Global Caché is doing our part to lessen our carbon footprint by providing recyclable packaging and reducing our paper output. For complete documentation and tutorials, visit: www.globalcache.com/docs The quick start below will get you started. Getting Started. Connect both an RJ45 (Ethernet) network cable and power supply to your iTach unit. If the iTach is PoE (Power over Ethernet) enabled, connecting a power supply is not necessary.
PAGE 2
Each iTach has an internal IR learner. To use it, download the iLearn application from our downloads page and go through the tutorial located at www.globalcache.com/docs. Once connected to your learner, simply point your remote at the small hole located to the right of the power connector, and input any button you want captured by iLearn. Troubleshooting.