Installation Guide

Framed Mirror Installation Guide
Damage may occur if the hanging hardware packed with this item is not
used.
This Item comes with tested D-Ring hardware attached to the back of
the frame and a J-Hook pack that meets the weight requirements.
Place the J-Hook flat against the wall and insert each nail at the angle
required by the pre-molded holes. Space the J-Hooks on the wall so that
they align with the hanging hardware that is attached to each side of the
frame back. This will give even distribution of weight and a safe
installation. The wall hooks included with the item have been tested by
installing the hooks in a ½ inch thick Gypsum Wallboard (Sheetrock).
THE CORRECT WAY
< D-RINGS >
Correct distribution of
weight using two hooks.
The weight of the mirror not properly
distributed places a strain at one point
on both wire and hangers.
THE UNSAFE WAY
< J-HOOKS >