Instructions / Assembly

EA1 EA1
EA1 Rev. 10/21/2008
5. REMOVE INSIDE TRIM 6. ADJUST OUTSIDE ROSE 7. INSTALL LOCK
8. INSTALL INSIDE ROSE 9. INSTALLATION OF INSIDE KNOB
10. RIGHT KEY HOLE POSITION
11. IN ORDER TO ADJUST THE ABNORMAL STATE OF THE KEY HOLE FACING
UPWARD, THE KNOB MUST BE PULLED OUT AND INSTALLED AGAIN.
THE METHOD OF INSTALLATION IS DESCRIBED AS BELOW D.
a
b
c
a
c
b
d
Use nail end of wrench provided to depress
inside knob catch in
hole of inside sleeve
collar and slide knob or
in side lever off spindle.
Depress spring attached
to inside rose. Insert nail
end of wrench into slot to
remove inside rose plate.
Remove inside rose and mounting plate.
Adjust lock to fit door thickness by
rotating outside rose.
Lock will fit all doors 1-3/8" to 1-3/4"
(35mm~45mm) thick.
Latch unit must be in place before
installing lock. Be sure lock housing
engages with latch prongs and
retractor interlocks with latch tail.
DOOR
CENTER LINE
Tighten machine screws securely to install
mounting plate.
Press rose onto mounting plate.
Be sure to fit rose in recess of mounting plate.
Upon installation of the lock, it may happen
that key hole faces upward or downward as
shown in the following drawing.
It is advisable to correct all key hole to be
facing downward.
First turn the knob
clockwise until the
knob catch appears
in the small hole.
With the other hand,
turn the key
counterclockwise
within the limit of
30°~90°
Install again
according to
the correct
direction.
Using a small nail
to press the knob
catch and pull the
knob out.
IMPORTANT-
Align lug on knob with narrow
slot on side of spindle and push knob
all the way in until knob catch clicks
into slot on knob.
Otherwise knob will jamb on shaft.
Tighten machine screws securely
A. FOR WOODEN DOOR
SLOT
LUG
DOWNWARD
CORRECT
UPWARD
INCORRECT
X
MOTE: Make sure that mounting plate fit
horizontally into slots notched in door.
B. FOR METAL DOOR
54mm (2-1/8")
TEMPLATE
64mm (2-33/64")
51 45 40 35 32
2" 1-3/4" 1-9/16" 1-3/8" 1-1/4"
FOR METAL DOOR ONLY
Mark ( ) hole at of
door edge.
1" 25.4mm center
Fit here on door edge
BACKSET 70mm (2-3/4")
BACKSET 60mm (2-3/8")
5.5mm (7/32") x2 HOLE
8mm (5/16") DEEP
Tighten machine
screws securely
NOTCH
NOTCH