User Manual

HIGH VELOCITY FLOOR FAN
READ AND SAVE THESE INSTRUCTIONS
1-800-645-2986
Operating Manual
Read and follow all instructions before operating fan.
Do not use fan if any part is damaged ormissing.
• To reduce the risk of fire or electrical shock, do not expose to water or rain.
• To reduce the risk of fire or electrical shock, do not use this fan with any solid state
speed control device.
• Automatically operated device - To reduce the risk of injury, disconnect from power
supply before servicing.
• If the power supply cord is damaged, contact your local service centre or a qualified
electrician to install an appropriate replacement cord to prevent any injury or damage.
• The appliance does not apply to be used in locations where special conditions prevail,
such as the presence of a corrosive or explosive atmosphere ( dust, vapour or gas ).
• This appliance is not intended for use by persons (including children) with reduced
physical, sensory or mental capabilities, or lack of experience and knowledge, unless
they have been given supervision or instruction concerning use of the appliance by a
person responsible for their safety.
• Children should be supervised to ensure that they do not play with the appliance.
1. Never insert fingers or any other objects through the grill guard when fan is in
operation.
2. Disconnect the fan from its power source when moving from one location to another.
3. Disconnect the fan from its power source when removing guards for cleaning.
4. Be sure fan is on a stable, flat surface when in operation.
5. Do not use fan in windows. Rain and moisture may create electrical hazard.
6. Close supervision is necessary when this fan is used near children, the elderly and
pets.
7. Do not place the fan near an open flame, cooking or heating appliance, or hot
surface.
8. This fan should not be operated outside.
Do not alter the fan's assembly.
Be sure that both front and rear guard screws are completely tightened in
locking position before operation.
Tilt fan head to the desired angle.
This high velocity fan can be used alone or in conjunction with air conditioning.
Rotating the fan head upward serves to pull air from the floor and circulate it throughout
the entire room.
Select air speed by setting switch to either HIGH(2) - LOW(1) - OFF(0).
It is normal for the motor to feel warm to touch after continuous operation.
This fan features a thermostat that will automatically shut off should it overheat for any
reason. If this happens, immediately unplug the fan from the outlet.
Unplug from electrical supply source before cleaning.
1. Use soft damp cloth to clean, then wipe with dry cloth.
2. Do not use a cleaning solution that is harmful to paints or plastics.
3. Do not bend the blades.
CAUTION:
WARNING:
CAUTION:
WARNING:
TO ADJUST AIRFLOW UPWARD OR DOWNWARD:
SPEED CONTROL:
WARNING:
RULES FOR SAFE OPERATION:
OPERATING INSTRUCTIONS
CLEANING
ASSEMBLY INSTRUCTIONS:
RATING
FE-90EdOL(E) 258320 120V~ 60Hz 485W 4.5A
ASSEMBLY INSTRUCTIONS:
STEP 1
STEP 2:
: TUBE BASE ASSEMBLY INSTRUCTIONS:
Assemble two wheels and tubes as shown on figure 1.
FAN HEAD ASSEMBLY INSTRUCTIONS:
1. Fan head can be assembled by sliding stand together and securing with the four
holding screws provided as shown on figure 2.
2. The fan have three position the desired for adjusting height of the fan.
wheel
washer
bolt
shaft
Set knob
Set knob
Support tube
tube