Assembly Instructions

DOUBLE TIER ASSEMBLY 6-TIER ASSEMBLY
BOTTOM
SIDE
SHELF
TOP
4. Repeat step 3 until bank
of lockers is complete.
Bolt on side
globalindustrial.com
Three Wide Locker Assembly
Assembly
Instructions
Customer Service
1-800-645-2986
Page 1
Please read the complete instructions.
Check for missing or damaged parts.
Only use the specified hardware. Always
use a #1 Bolt with bolt head out unless
otherwise specified.
CAUTION: Some parts have sharp edges
and corners, wear gloves during assembly.
Assembly will require the following tools:
• 2 drift pins (or 2 nail punches) for hole
alignment
• 3/8" socket wrench
Lockers should be assembled on a flat, level
surface and anchored according to the
instructions found in Section 7 & 9.
Locker Assembly
Before Assembly
1. Bolt together top and bottom with bends
facing down and the back with the bends
facing up. Top and bottom are identical.
For single and double-tier models, bolt
hook to back.
2. Bolt on side with bend in rear and facing in. Omit 2 bolts near bottom rear
for legs. Install shelf by bolting to side with bend facing down and 45°
bend in front. (See Section 8 Punching Patterns for single, double and 6-
tier shelf hole locations.)
3. Bolt together tops, bottoms,
shelves, and backs with a side
in between.
BACK
BOTTOM
TOP
SIDE
BOTTOM
TOP
SHELF
BACK
DOUBLE TIER ASSEMBLY 6-TIER ASSEMBLY
SINGLE TIER
ASSEMBLY
DOUBLE TIER ASSEMBLY 6-TIER ASSEMBLY
BOTTOM
SIDE
SHELF
TOP
BACK
6-Tier Double-Tier
Single-Tier