Instruction Manual High Lift Hand Truck Note: The Owner/Operator must read carefully and understand all the information presented here before operation.
CONTENT 1. Specification…………………………………………. 2 2. Safety Instructions…….…………………………….. 2 3. Installation & Adjustment…………………………… 3 3.1 Screw (part ……………… 3.2 Handle………………………………………… 3 4. Trouble Shooting Guide………………………….…. 6 5. Exploded View & Part List………………………….. 7 5.1 Fork Exploded View ………………………… 7 5.2 Pump Assembly Exploded View……….…... 9 2 No.158)………….
THANK YOU FOR USING THIS HIGH LIFT HAND TRUCK. FOR YOUR SAFETY AND CORRECT OPERATION, PLEASE CAREFULLY READ THIS INSTRUCTION BEFORE USING IT. NOTE: All of the information reported herein is based on data available at the moment of printing. The factory reserves the right to modify its own products at any moment without notice and incurring in any sanction. So it is suggested to always verify possible updates. 1. SPECIFICATIONS Model Rated lifting capacity Max. Fork height Min.
3. INSTALLATION & ADJUSTMENT 1. Screw(part No.158) ● To prevent oil-leaking from oil tank during transportation, Air Screw (part No.158) is replaced with Oil-sealing Screw in the factory. But it has to be replaced back when you put this truck in use. ● How to change: Screw out Oil-sealing Screw, then screw in Air Screw With which the Pump housing(No.160) is hung, thus keep oil tank always connecting with atmosphere. 2.
Position I: Quick lifting for fork. Position II: Slow lifting for fork. Position III: Descending for fork. ● Test different functions by putting the Release Lever in 3 different positions respectively. If it does not function properly, then adjusting Lock Nut (No.113) by following process.
See picture 3 When pushing the handle down, the fork can’t be lifted instantly. Please loosen the Screw (No.130) on the pump while pushing the handle down slowly to release the air from the pump. Then tighten the screw. ● When to add oil See Picture 3 If the fork can’t be pumped up to its rated highest position, you may have to add hydraulic oil into the oil tank. The hydraulic fluid to be used must have a quality of ISO VG22 or equivalence.
4.TROUBLE SHOOTING GUIDE Items Symptom Possible cause Aliments 1 1． Low oil level in oil 1 .Add proper hydraulic oil. tank. 2. Fast operating the 2． Exist air in the handle for several hydraulic system. Fork can not be times. Bleed the pumped up system. 3. Adjusting nut is not 3. Adjust adjusting nut. adjusted properly. (see picture 2) 2 1. Check and remove the 1． Fork blocked. block. 2． Adjusting nut not Fork can’t be 2. Adjust adjusting nut adjusted properly. released down properly.
5. EXPLODED VIEW & PART LIST 5.
No. 1 2 3 4 5 6 7 8 9 10 11 12 13 14 15 16 17 18 19 20 21 22 23 24 25 26 27 28 31 32 30 Description Fork Screw Nut Power Unit Hold Yoke Wheel Yoke Centrifugal Axle Spacer Steering Wheel Snap Ring Pin Snap Ring Bush Leg Leg Bush Pin Washer Nut Washer Ball Bearing Front Wheel Wheel Axle Roller Bush Washer Spring Washer Nut Screw Nut Steering Wheel Assembly (incls.6,9,10,21、31、32) 5.
Part No. DESCRIPTION QTY Part No.
Part No. DESCRIPTION QTY Part No.
