User Manual

Instruction Manual

Outdoor Drinking Fountain w/ Bottle Filler

INSTALLATION

• It is recommended that 2 or more people install this unit.

• This fountain must be mounted on a solid, flat surface with adequate strength (concrete

pad recommended) capable of supporting 400 lbs.

• Locate and install plumbing through ground as required. Refer to Rough-In Guide (page 4)

for proper location and correct plumbing.

• Install a drainable shut-off valve (not included) if in a freezable environment.

• Installation of a trap on the water drain line may be necessary; check local plumbing codes.

WARNING: The fountain is rated for inlet water pressure of 20-105 PSI. A pressure reducing

regulator should be used if the inlet water supply exceeds 105 PSI. Any damage caused by

reason of connecting this product to supply line pressure higher than 105 PSI will void warranty.

Flat-head anti-theft screw

M6 x 10 (qty 24)

1. REMOVE ACCESS PANELS

REMOVE

To gain access to the drain and water line connections, remove all access panels detailed below

using the provided torx key wrench (H1) or torx drill bit (H2) to remove all (24) M6 x 10

flat-head anti-theft screws on back side of the bottle filler and pedestal, as well as the underside

of the drinking fountain pan:

REMOVE