User Manual

Instruction Manual
8
Outdoor Drinking Fountain w/ Bottle Filler
FIG. 1
3/8” O.D. TUBE CONNECT
COLD WATER SUPPLY
B CA
SIMPLY PUSH IN
TUBE TO ATTACH
TUBE IS SECURED
IN POSITION
PUSH IN COLLET
TO RELEASE TUBE
SIMPLY PUSH IN
TUBE TO ATTACH
TUBE IS SECURED
IN POSITION
PUSH IN COLLET
TO RELEASE TUBE
A B C
FIG. 2
WATER INLET LINE CONNECTION BREAKDOWN:
Install Shut-off Valve
(Not Included)
PUSHING TUBE IN BEFORE
PULLING IT OUT HELPS TO
RELEASE TUBE
OPERATION OF QUICK CONNECT FITTINGS
NOTE: WATERFLOW DIRECTION
• If drinking fountain is being installed in areas where cold temperatures may occur, wrap
pipe insulation (P7) around all water inlet lines.
• Installation of a trap on the water drain line may be necessary; check local codes.
Always remove trap before winterization draining.
CAUTION: Before freezing temperatures occur, see Draining and Winterization section
of this manual (page 11) for proper preparation.
P5
(39-1/2”)
P5
(25-1/2”)
P6
(31-1/2”)
P4
P3
WATER
SOURCE
SIDE VIEW
FRONT VIEW
P2
P5
(25-1/2”)
P5
(6-1/4”)
P3
P4: Straight Flow Check Valve:
All Water Inlet Connec�ons: