Assembly Instructions

Before you begin: Check components to verify all are included. Assembly requires two people and must be performed on a flat and

even surface. Do not overtighten hardware as damage can occur.

As of 01/2020

Page 1 of 3

CONTENTS

Ref. Qty. Description

1 1

Pre-Assembled

Top

2 3

Base

Supports

3 3

Left Seats

Ref. Qty. Description

4 3

Support

Arms

5 6 Anchor

Blocks

H1 1

Hardware

Pack*

72” Hex Table

Assembly Instructions

Customer Service

US: 1-800-645-2986

Model #s: B264040, B264042, B2331053

Right Seats

*Contains: (6) 2 1/2" Hex Lag Screws

(30) 3 1/2" Hex Lag Screws

(36) Flat Washers

(9) 3" Deck Screws

Step 1

Secure anchor blocks to the bottom of each seat using 3 1/2" hex

lag screws and flat washers. The pre-drilled hole in the block will

face the seat side with three edges. Each seat will have one (1)

anchor block.

Step 2

Place the three (3) support arms on a flat surface. Fasten the

support arms together with 3" deck screws, two (2) per side.

Do not overtighten.

PAGE 1
72” Hex Table Assembly Instructions TM Model #s: B264040, B264042, B2331053 Assembly Instructions Customer Service US: 1-800-645-2986 CONTENTS Ref. Qty. 1 1 2 3 3 3 Description Pre-Assembled Top Base Supports Ref. Qty. 4 3 5 6 H1 1 Left Seats Right Seats Description Support Arms Anchor Blocks Hardware Pack* *Contains: (6) 2 1/2" Hex Lag Screws (30) 3 1/2" Hex Lag Screws (36) Flat Washers (9) 3" Deck Screws Before you begin: Check components to verify all are included.
PAGE 2
Step 3 The three (3) base support legs are rotated for shipping purposes. A single deck screw is pre-installed, rotate the leg 90 degrees and align the pre-drilled holes. Secure the leg with a supplied deck screw. Repeat for all three (3) legs. Step 4 With the assembled support arms on a flat surface, position a LH and RH seat with the flat edges aligned at the center point of the middle board of the arm assembly.
PAGE 3
Step 7 With two people, carefully lift the table top and position the slots in the top underside frame with the three (3) base legs, slide the top down on the legs. Ensure each base leg is fully engaged in the slot and the top is resting even and level. B Step 8 C B B A A C C Remove the item used to support the arm assembly to allow for proper positioning. Ensure the bases are resting flat on the mounting surface, position the horizontal arm with the pre-drilled hole in line with the base leg.