User's Manual

This device complies with Part 15 of the FCC Rules. Operation is subject to the following conditions:
(1) This device may not cause harmful interference
(2) This device must accept any interference receiv ed, including interference that may cause undesired operation
Important: Changes or modifications to this unit not expressly approved by XACT could void your authority to operate this
unit. Your COMMUNICATOR is set up to transmit a regulated signal on an assigned frequency. It is against the law to
alter or adjust the settings inside the COMMUNICATOR to exceed those limitations. Any adjustment to your
COMMUNICATOR must be made by qualified technicians.
To be safe and sure:
• Never open your COMMUNICATOR’s case.
• Never change or replace anything in your COMMUNICATOR except the battery.
Your COMMUNICATOR might cause TV or COMMUNICATOR interference even when it is operating properly. To
determine whether your COMMUNICATOR is causing the interference, turn it off. If the interference goes away, your
COMMUNICATOR is causing it. Try to eliminate the interference by moving your COMMUNICATOR away from the
receiver. If you cannot eliminate the interference, the FCC requires that you stop using the COMMUNICATOR.
Hazardous Environments: Do not operate the COMMUNICATOR in hazardous environments. Explosion or fire may
result. Do not operate the COMMUNICATOR near unshielded electrical blasting caps. Under certain conditions,
COMMUNICATORs can interfere with blasting operations and may cause an explosion. Turn your COMMUNICATOR
OFF to prevent accidental transmission when in a blasting area or in areas posted: “Turn off two-way COMMUNICATOR.”
Construction crews often use remote control RF devices to set off explosives.
Care and Safety: To clean the COMMUNICATOR, use a soft cloth dampened with water. Do not use cleaners or
solvents because they can harm the body of the unit and leak inside, causing permanent damage. Use a dry, lint-free
cloth to clean the
battery contacts. Do not submerge the unit in water or attempt to use the unit on a wet environment. If the unit gets
wet, turn it off, and remove the battery immediately. Dry the battery and the battery compartment with a soft cloth to
minimize potential water damage. Leave the battery compartment cover off overnight to ensure complete drying. Do not
use the COMMUNICATOR until the unit is completely dry.
FCC INFORMATION