- GMC Blower Vacuum Instruction Manual

ManualsBrandsGlobal Machinery Company ManualsBlowerBV2400

Unpacking

Due to modern mass production techniques, it is unlikely

that your power tool is faulty or that a part is missing. If

you find anything wrong, do not operate the tool until the

parts have been replaced or the fault has been rectified.

Failure to do so could result in serious personal injury.

Fitting the collection bag

1. Connect the strap (fig A)

onto the hook on the

underside of the blower

vacuum housing (fig B).

2. Attach the push-on plastic

connector (fig C) to the

outlet tube of the housing

(fig D). Push the fitting

of the collection bag

directly onto the outlet

until it “clicks”

into position (fig E).

3. To remove the collection

bag, disconnect the

attachments in the

reverse order.

4. When removing the

fitting on the outlet,

first depress the two

buttons on either side

of the plastic connector

(fig F), and then pull

downwards on the fitting.

Finally, remove the strap

from the hook under the

blow/vacuum tube.

Operation of the blower vac

Prior to using the blower vac, ensure you have read and

understood this instruction manual.

• Ensure you are wearing suitable clothing and also safety

equipment like safety glasses, ear protection and a

mask if necessary.

• Ensure the attachments to the blower vac are correctly

fitted and adjusted.

• Be aware of other people and animals in the area where

you are to be operating the blower vac.

To turn the blower vac on

1. Plug the power cord into

an approved electrical

extension cord, and turn

the extension cord on.

2. Ensuring the blower vac is

directed in a safe direction,

depress the trigger switch

(1) and the blower vac will

start. (fig G).

Be sure to be holding the blower vac firmly on start up.

To turn the blower vac off

To turn the blower vac “off”, simply release the trigger switch.

Important. After you have turned the blower vac off, do

not leave the product until the blower vac has been fully

disconnected from the electrical supply.

To select the blow operation

1. Move the blower/vacuum

selector lever (2) towards

the back of the housing

(fig H).

When the blow operation

is selected, air is drawn up

through the large blow/vac

tube and then expelled at a

much higher velocity in the